On Fri, Nov 02, 2018 at 02:31:29PM -0700, Manasi Navare wrote:
> From: Gaurav K Singh <gaurav.k.singh@xxxxxxxxx>
>
> This computation of RC params happens in the atomic commit phase
> during compute_config() to validate if display stream compression
> can be enabled for the requested mode.
>
> v7 (From Manasi):
> * Use DRM_DEBUG instead of DRM_ERROR (Ville)
> * Use Error numberinstead of -1 (Ville)
> v6 (From Manasi):
> * Use 9 instead of 0x9 for consistency (Anusha)
>
> v5 (From Manasi):
> * Fix dim checkpatch warnings/checks
> v4(From Gaurav):
> * No change.Rebase on drm-tip
>
> v3 (From Gaurav):
> * Rebase on top of Manasi's latest series
> * Return -ve value in case of failure scenarios (Manasi)
>
> Fix review comments from Ville:
> * Remove unnecessary comments
> * Remove unnecessary paranthesis
> * Add comments for few RC params calculations
>
> v2 (From Manasi):
> * Rebase Gaurav's patch from intel-gfx to gfx-internal
> * Use struct drm_dsc_cfg instead of struct intel_dp
> as a parameter
>
> Cc: Manasi Navare <manasi.d.navare@xxxxxxxxx>
> Cc: Jani Nikula <jani.nikula@xxxxxxxxxxxxxxx>
> Cc: Ville Syrjala <ville.syrjala@xxxxxxxxxxxxxxx>
> Signed-off-by: Gaurav K Singh <gaurav.k.singh@xxxxxxxxx>
> Signed-off-by: Manasi Navare <manasi.d.navare@xxxxxxxxx>
> Reviewed-by: Anusha Srivatsa <anusha.srivatsa@xxxxxxxxx>
> ---
> drivers/gpu/drm/i915/intel_vdsc.c | 127 ++++++++++++++++++++++++++++++
> 1 file changed, 127 insertions(+)
>
> diff --git a/drivers/gpu/drm/i915/intel_vdsc.c b/drivers/gpu/drm/i915/intel_vdsc.c
> index 0a1918f2f643..a76f78b9c0ee 100644
> --- a/drivers/gpu/drm/i915/intel_vdsc.c
> +++ b/drivers/gpu/drm/i915/intel_vdsc.c
> @@ -317,6 +317,130 @@ static int get_column_index_for_rc_params(u8 bits_per_component)
> }
> }
>
> +static int intel_compute_rc_parameters(struct drm_dsc_config *vdsc_cfg)
> +{
> + unsigned long groups_per_line = 0;
> + unsigned long groups_total = 0;
> + unsigned long num_extra_mux_bits = 0;
> + unsigned long slice_bits = 0;
> + unsigned long hrd_delay = 0;
> + unsigned long final_scale = 0;
> + unsigned long rbs_min = 0;
> +
> + /* Number of groups used to code each line of a slice */
> + groups_per_line = DIV_ROUND_UP(vdsc_cfg->slice_width,
> + DSC_RC_PIXELS_PER_GROUP);
> +
> + /* chunksize in Bytes */
> + vdsc_cfg->slice_chunk_size = DIV_ROUND_UP(vdsc_cfg->slice_width *
> + vdsc_cfg->bits_per_pixel,
> + (8 * 16));
> +
> + if (vdsc_cfg->convert_rgb)
> + num_extra_mux_bits = 3 * (vdsc_cfg->mux_word_size +
> + (4 * vdsc_cfg->bits_per_component + 4)
> + - 2);
> + else
> + num_extra_mux_bits = 3 * vdsc_cfg->mux_word_size +
> + (4 * vdsc_cfg->bits_per_component + 4) +
> + 2 * (4 * vdsc_cfg->bits_per_component) - 2;
> + /* Number of bits in one Slice */
> + slice_bits = 8 * vdsc_cfg->slice_chunk_size * vdsc_cfg->slice_height;
> +
> + while ((num_extra_mux_bits > 0) &&
> + ((slice_bits - num_extra_mux_bits) % vdsc_cfg->mux_word_size))
> + num_extra_mux_bits--;
> +
> + if (groups_per_line < vdsc_cfg->initial_scale_value - 8)
> + vdsc_cfg->initial_scale_value = groups_per_line + 8;
> +
> + /* scale_decrement_interval calculation according to DSC spec 1.11 */
> + if (vdsc_cfg->initial_scale_value > 8)
> + vdsc_cfg->scale_decrement_interval = groups_per_line /
> + (vdsc_cfg->initial_scale_value - 8);
> + else
> + vdsc_cfg->scale_decrement_interval = DSC_SCALE_DECREMENT_INTERVAL_MAX;
> +
> + vdsc_cfg->final_offset = vdsc_cfg->rc_model_size -
> + (vdsc_cfg->initial_xmit_delay *
> + vdsc_cfg->bits_per_pixel + 8) / 16 + num_extra_mux_bits;
> +
> + if (vdsc_cfg->final_offset >= vdsc_cfg->rc_model_size) {
> + DRM_DEBUG_KMS("FinalOfs < RcModelSze for this InitialXmitDelay\n");
> + return -EINVAL;
> + }
> +
> + final_scale = (vdsc_cfg->rc_model_size * 8) /
> + (vdsc_cfg->rc_model_size - vdsc_cfg->final_offset);
> + if (vdsc_cfg->slice_height > 1)
> + /*
> + * NflBpgOffset is 16 bit value with 11 fractional bits
> + * hence we multiply by 2^11 for preserving the
> + * fractional part
> + */
> + vdsc_cfg->nfl_bpg_offset = DIV_ROUND_UP((vdsc_cfg->first_line_bpg_offset << 11),
> + (vdsc_cfg->slice_height - 1));
> + else
> + vdsc_cfg->nfl_bpg_offset = 0;
> +
> + /* 2^16 - 1 */
> + if (vdsc_cfg->nfl_bpg_offset > 65535) {
> + DRM_DEBUG_KMS("NflBpgOffset is too large for this slice height\n");
> + return -EINVAL;
> + }
> +
> + /* Number of groups used to code the entire slice */
> + groups_total = groups_per_line * vdsc_cfg->slice_height;
> +
> + /* slice_bpg_offset is 16 bit value with 11 fractional bits */
> + vdsc_cfg->slice_bpg_offset = DIV_ROUND_UP(((vdsc_cfg->rc_model_size -
> + vdsc_cfg->initial_offset +
> + num_extra_mux_bits) << 11),
> + groups_total);
> +
> + if (final_scale > 9) {
> + /*
> + * ScaleIncrementInterval =
> + * finaloffset/((NflBpgOffset + SliceBpgOffset)*8(finalscale - 1.125))
> + * as (NflBpgOffset + SliceBpgOffset) has 11 bit fractional value,
> + * we need divide by 2^11 from pstDscCfg values
> + */
> + vdsc_cfg->scale_increment_interval =
> + (vdsc_cfg->final_offset * (1 << 11)) /
> + ((vdsc_cfg->nfl_bpg_offset +
> + vdsc_cfg->slice_bpg_offset)*
> + (final_scale - 9));
> + } else {
> + /*
> + * If finalScaleValue is less than or equal to 9, a value of 0 should
> + * be used to disable the scale increment at the end of the slice
> + */
> + vdsc_cfg->scale_increment_interval = 0;
> + }
> +
> + if (vdsc_cfg->scale_increment_interval > 65535) {
> + DRM_DEBUG_KMS("ScaleIncrementInterval is large for slice height\n");
> + return -EINVAL;
> + }
> +
> + /*
> + * DSC spec mentions that bits_per_pixel specifies the target
> + * bits/pixel (bpp) rate that is used by the encoder,
> + * in steps of 1/16 of a bit per pixel
> + */
> + rbs_min = vdsc_cfg->rc_model_size - vdsc_cfg->initial_offset +
> + DIV_ROUND_UP(vdsc_cfg->initial_xmit_delay *
> + vdsc_cfg->bits_per_pixel, 16) +
> + groups_per_line * vdsc_cfg->first_line_bpg_offset;
> +
> + hrd_delay = DIV_ROUND_UP((rbs_min * 16), vdsc_cfg->bits_per_pixel);
> + vdsc_cfg->rc_bits = (hrd_delay * vdsc_cfg->bits_per_pixel) / 16;
> + vdsc_cfg->initial_dec_delay = hrd_delay - vdsc_cfg->initial_xmit_delay;
> +
> + return 0;
> +}
> +
> +
> int intel_dp_compute_dsc_params(struct intel_dp *intel_dp,
> struct intel_crtc_state *pipe_config)
> {
> @@ -451,5 +575,8 @@ int intel_dp_compute_dsc_params(struct intel_dp *intel_dp,
> vdsc_cfg->initial_scale_value = (vdsc_cfg->rc_model_size << 3) /
> (vdsc_cfg->rc_model_size - vdsc_cfg->initial_offset);
>
> + if (intel_compute_rc_parameters(vdsc_cfg) < 0)
> + return -EINVAL;
One should pretty much always pass on the errno rather than inventing a
new one on the spot.
> +
> return 0;
> }
> --
> 2.18.0
--
Ville Syrjälä
Intel
_______________________________________________
Intel-gfx mailing list
Intel-gfx@xxxxxxxxxxxxxxxxxxxxx
https://lists.freedesktop.org/mailman/listinfo/intel-gfx
