For PSR2 there is no register to tell HW to keep main link enabled
while PSR2 is active, so don't configure sink DPCD with a
wrong value.
v4: rebased on top of the patch removing link standby from debugfs
Cc: Dhinakaran Pandiyan <dhinakaran.pandiyan@xxxxxxxxx>
Signed-off-by: José Roberto de Souza <jose.souza@xxxxxxxxx>
---
drivers/gpu/drm/i915/intel_psr.c | 10 ++++++----
1 file changed, 6 insertions(+), 4 deletions(-)
diff --git a/drivers/gpu/drm/i915/intel_psr.c b/drivers/gpu/drm/i915/intel_psr.c
index 423cdf84059c..26317a4e03d2 100644
--- a/drivers/gpu/drm/i915/intel_psr.c
+++ b/drivers/gpu/drm/i915/intel_psr.c
@@ -346,12 +346,14 @@ static void intel_psr_enable_sink(struct intel_dp *intel_dp)
drm_dp_dpcd_writeb(&intel_dp->aux, DP_RECEIVER_ALPM_CONFIG,
DP_ALPM_ENABLE);
dpcd_val |= DP_PSR_ENABLE_PSR2;
+ } else {
+ if (dev_priv->psr.link_standby)
+ dpcd_val |= DP_PSR_MAIN_LINK_ACTIVE;
+
+ if (INTEL_GEN(dev_priv) >= 8)
+ dpcd_val |= DP_PSR_CRC_VERIFICATION;
}
- if (dev_priv->psr.link_standby)
- dpcd_val |= DP_PSR_MAIN_LINK_ACTIVE;
- if (!dev_priv->psr.psr2_enabled && INTEL_GEN(dev_priv) >= 8)
- dpcd_val |= DP_PSR_CRC_VERIFICATION;
drm_dp_dpcd_writeb(&intel_dp->aux, DP_PSR_EN_CFG, dpcd_val);
drm_dp_dpcd_writeb(&intel_dp->aux, DP_SET_POWER, DP_SET_POWER_D0);
--
2.19.0
_______________________________________________
Intel-gfx mailing list
Intel-gfx@xxxxxxxxxxxxxxxxxxxxx
https://lists.freedesktop.org/mailman/listinfo/intel-gfx
