Previously we would enable hotplug polling on the outputs immediately upon construction. This would allow a very early hotplug event to trigger before we had finishing setting up the driver to handle it. Instead, move the output polling to the last step of registration, after we have set up all handlers, including the fbdev configuration. Signed-off-by: Chris Wilson <chris@xxxxxxxxxxxxxxxxxx> Cc: Daniel Vetter <daniel.vetter@xxxxxxxx> Cc: Ville Syrjala <ville.syrjala@xxxxxxxxxxxxxxx> Cc: Maarten Lankhorst <maarten.lankhorst@xxxxxxxxxxxxxxx> --- drivers/gpu/drm/i915/i915_drv.c | 5 +++-- 1 file changed, 3 insertions(+), 2 deletions(-) diff --git a/drivers/gpu/drm/i915/i915_drv.c b/drivers/gpu/drm/i915/i915_drv.c index 0793a27e2b95..c178cbfdb4c2 100644 --- a/drivers/gpu/drm/i915/i915_drv.c +++ b/drivers/gpu/drm/i915/i915_drv.c @@ -693,8 +693,6 @@ static int i915_load_modeset_init(struct drm_device *dev) /* Only enable hotplug handling once the fbdev is fully set up. */ intel_hpd_init(dev_priv); - drm_kms_helper_poll_init(dev); - return 0; cleanup_gem: @@ -1255,6 +1253,9 @@ static void i915_driver_register(struct drm_i915_private *dev_priv) * cannot run before the connectors are registered. */ intel_fbdev_initial_config_async(dev); + + if (INTEL_INFO(dev_priv)->num_pipes) + drm_kms_helper_poll_init(dev); } /** -- 2.15.0 _______________________________________________ Intel-gfx mailing list Intel-gfx@xxxxxxxxxxxxxxxxxxxxx https://lists.freedesktop.org/mailman/listinfo/intel-gfx
