From: Uma Shankar <uma.shankar@xxxxxxxxx>
This reverts commit bbdf0b2ff32aa75c7bd167569130e9391d2e6282.
Disable device ready before shutdown command was added previously to avoid a
split screen issue seen on dual link DSI panels. As of now, dual link is not
supported and will need some rework in the upstream code. For single link DSI
panels, the change is not required. This will cause failure in sending SHUTDOWN
packet during disable. Hence reverting the change. Will handle the change
as part of dual link enabling in upstream.
Signed-off-by: Uma Shankar <uma.shankar@xxxxxxxxx>
Signed-off-by: Vidya Srinivas <vidya.srinivas@xxxxxxxxx>
---
drivers/gpu/drm/i915/intel_dsi.c | 11 -----------
1 file changed, 11 deletions(-)
diff --git a/drivers/gpu/drm/i915/intel_dsi.c b/drivers/gpu/drm/i915/intel_dsi.c
index 2a0f5d3..fc25d7d 100644
--- a/drivers/gpu/drm/i915/intel_dsi.c
+++ b/drivers/gpu/drm/i915/intel_dsi.c
@@ -892,8 +892,6 @@ static void intel_dsi_disable(struct intel_encoder *encoder,
const struct intel_crtc_state *old_crtc_state,
const struct drm_connector_state *old_conn_state)
{
- struct drm_device *dev = encoder->base.dev;
- struct drm_i915_private *dev_priv = dev->dev_private;
struct intel_dsi *intel_dsi = enc_to_intel_dsi(&encoder->base);
enum port port;
@@ -903,15 +901,6 @@ static void intel_dsi_disable(struct intel_encoder *encoder,
intel_panel_disable_backlight(old_conn_state);
/*
- * Disable Device ready before the port shutdown in order
- * to avoid split screen
- */
- if (IS_BROXTON(dev_priv)) {
- for_each_dsi_port(port, intel_dsi->ports)
- I915_WRITE(MIPI_DEVICE_READY(port), 0);
- }
-
- /*
* According to the spec we should send SHUTDOWN before
* MIPI_SEQ_DISPLAY_OFF only for v3+ VBTs, but field testing
* has shown that the v3 sequence works for v2 VBTs too
--
1.9.1
_______________________________________________
Intel-gfx mailing list
Intel-gfx@xxxxxxxxxxxxxxxxxxxxx
https://lists.freedesktop.org/mailman/listinfo/intel-gfx
