|
Hi, I am executing the DP compliance test suite and the only test currently failing with the drm-tip + my patch (https://patchwork.freedesktop.org/series/25191/) Is the power management test (4.4.3) where it expects the source DUT to go into Power state D3 by setting DPCD register 0x600 to 2 as requested by the test GUI and then exit to normal operation by writing 1 to that DPCD register. I see that in the code intel_dp_sink_dpms() with DPMS_OFF will set that register to 2 and then with DPMS on it sets it to 1, but since that happens only during encoder disable and enable, I am not sure how it will happen through this test. Any thoughts? Please refer to the section 4.4.3 in the CTS spec. Regards Manasi Navare Graphics Kernel Developer OTC, Intel Corporation |
_______________________________________________ Intel-gfx mailing list Intel-gfx@xxxxxxxxxxxxxxxxxxxxx https://lists.freedesktop.org/mailman/listinfo/intel-gfx
