As per BSPEC, high/low switch count to be programmed in terms of byteclock using exit_zero_count and prep_count. For Geminilake exit/prep counts are already calculated in terms of byteclock. This patch calculates high/low switch count using counts value in byteclock, old calculation leads to screen flicker/shift issue while resuming from S3/S4. Signed-off-by: Madhav Chauhan <madhav.chauhan@xxxxxxxxx> --- drivers/gpu/drm/i915/intel_dsi_vbt.c | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-) diff --git a/drivers/gpu/drm/i915/intel_dsi_vbt.c b/drivers/gpu/drm/i915/intel_dsi_vbt.c index 0dce779..7158c7c 100644 --- a/drivers/gpu/drm/i915/intel_dsi_vbt.c +++ b/drivers/gpu/drm/i915/intel_dsi_vbt.c @@ -694,8 +694,8 @@ bool intel_dsi_vbt_init(struct intel_dsi *intel_dsi, u16 panel_id) clk_zero_cnt << 8 | prepare_cnt; /* - * LP to HS switch count = 4TLPX + PREP_COUNT * 2 + EXIT_ZERO_COUNT * 2 - * + 10UI + Extra Byte Count + * LP to HS switch count = 4TLPX + PREP_COUNT * mul + EXIT_ZERO_COUNT * + * mul + 10UI + Extra Byte Count * * HS to LP switch count = THS-TRAIL + 2TLPX + Extra Byte Count * Extra Byte Count is calculated according to number of lanes. @@ -708,8 +708,8 @@ bool intel_dsi_vbt_init(struct intel_dsi *intel_dsi, u16 panel_id) /* B044 */ /* FIXME: * The comment above does not match with the code */ - lp_to_hs_switch = DIV_ROUND_UP(4 * tlpx_ui + prepare_cnt * 2 + - exit_zero_cnt * 2 + 10, 8); + lp_to_hs_switch = DIV_ROUND_UP(4 * tlpx_ui + prepare_cnt * mul + + exit_zero_cnt * mul + 10, 8); hs_to_lp_switch = DIV_ROUND_UP(mipi_config->ths_trail + 2 * tlpx_ui, 8); -- 1.9.1 _______________________________________________ Intel-gfx mailing list Intel-gfx@xxxxxxxxxxxxxxxxxxxxx https://lists.freedesktop.org/mailman/listinfo/intel-gfx
