Execute MIPI_SEQ_DEASSERT_RESET before putting the device in ready state (LP-11), this is the sequence in which things should be done according to the spec. Signed-off-by: Hans de Goede <hdegoede@xxxxxxxxxx> --- drivers/gpu/drm/i915/intel_dsi.c | 9 +++++++-- 1 file changed, 7 insertions(+), 2 deletions(-) diff --git a/drivers/gpu/drm/i915/intel_dsi.c b/drivers/gpu/drm/i915/intel_dsi.c index 9e3cf54..03a7a7c 100644 --- a/drivers/gpu/drm/i915/intel_dsi.c +++ b/drivers/gpu/drm/i915/intel_dsi.c @@ -653,10 +653,13 @@ static void intel_dsi_pre_enable(struct intel_encoder *encoder, intel_dsi_exec_vbt_sequence(intel_dsi, MIPI_SEQ_POWER_ON); msleep(intel_dsi->panel_on_delay); - /* put device in ready state */ + /* Deassert reset */ + intel_dsi_exec_vbt_sequence(intel_dsi, MIPI_SEQ_DEASSERT_RESET); + + /* Put device in ready state (LP-11) */ intel_dsi_device_ready(encoder); - intel_dsi_exec_vbt_sequence(intel_dsi, MIPI_SEQ_DEASSERT_RESET); + /* Send initialization commands in LP mode */ intel_dsi_exec_vbt_sequence(intel_dsi, MIPI_SEQ_INIT_OTP); /* Enable port in pre-enable phase itself because as per hw team @@ -737,6 +740,7 @@ static void intel_dsi_post_disable(struct intel_encoder *encoder, intel_dsi_exec_vbt_sequence(intel_dsi, MIPI_SEQ_BACKLIGHT_OFF); intel_dsi_exec_vbt_sequence(intel_dsi, MIPI_SEQ_DISPLAY_OFF); + /* Transition to LP-00 */ intel_dsi_clear_device_ready(encoder); intel_disable_dsi_pll(encoder); @@ -749,6 +753,7 @@ static void intel_dsi_post_disable(struct intel_encoder *encoder, I915_WRITE(DSPCLK_GATE_D, val); } + /* Assert reset */ intel_dsi_exec_vbt_sequence(intel_dsi, MIPI_SEQ_ASSERT_RESET); /* Power off, try both CRC pmic gpio and VBT */ -- 2.9.3 _______________________________________________ Intel-gfx mailing list Intel-gfx@xxxxxxxxxxxxxxxxxxxxx https://lists.freedesktop.org/mailman/listinfo/intel-gfx
