In message <m2r4t0jx2l.wl%randy@xxxxxxx>, Randy Bush writes: > > - 'Basic Requirements for IPv6 Customer Edge Routers' > > <draft-ietf-v6ops-6204bis-09.txt> as Informational RFC > > this document persists in confusing routing and forwarding. > > there are no routing protocols, a la 1812, here. there is confused text > such as > > 4.1. General Requirements > > The IPv6 CE router is responsible for implementing IPv6 routing; that > is, the IPv6 CE router must look up the IPv6 destination address in > its routing table to decide to which interface it should send the > packet. > > which i thought was forwarding, not routing. It's static routing. And if there is down stream PD there will be next hop routers as well as interfaces in the table. > RA/RD doeth not a router make. > > randy > _______________________________________________ > v6ops mailing list > v6ops@xxxxxxxx > https://www.ietf.org/mailman/listinfo/v6ops -- Mark Andrews, ISC 1 Seymour St., Dundas Valley, NSW 2117, Australia PHONE: +61 2 9871 4742 INTERNET: marka@xxxxxxx