On Thu, Mar 03, 2016 at 01:20:40PM -0800, Isaac Konikoff wrote: > My test has two hostapd AP's setup for 802.11r FT-EAP with a separate > hostapd radius server. A station can connect to either AP and when the > station is reset, it switches to the other AP. But I am unable to get > a roam to work. > > I'm not sure I have completely correct configs (attached) for > 802.11r...just tried to follow past examples I've found on this list. > The station 00:0e:8e:3d:30:e3 is connected to vap3 00:0e:8e:76:e6:71 > then I issue a wpa_cli scan then roam to vap2 00:0e:8e:1c:c6:b5...the > hostapd log from vap2 shows: > > 1456965227.209282: FT: Send PMK-R1 pull request to remote R0KH address > 00:0e:8e:76:e6:71 > 1456965227.209649: FT: RRB send to 00:0e:8e:76:e6:71 > 1456965227.209661: FT: Callback postponed until response is available > > Below is a bit of the supplicant log. > > Would any other logging help debug this? Yes, would need to see full hostapd log from both APs. -- Jouni Malinen PGP id EFC895FA _______________________________________________ Hostap mailing list Hostap@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/hostap
