Re: [CONF] enable 802.11AC in hostapd

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Fri, Dec 18, 2015 at 2:44 AM, Jouni Malinen <j@xxxxx> wrote:
>
> On Thu, Dec 17, 2015 at 05:45:45PM +0100, Alexandre Epert wrote:
> > wlan1: IEEE 802.11 Configured channel (36) not found from the channel list of current mode (0) IEEE 802.11b
>
> hw_mode was not set correctly.
>
> > Here is my hostapd.conf file :
> >
> > interface=wlan1
> > bridge=br0
> > #hw_mode=a
> > channel=36
>
> Why was that hw_mode commented out? Uncommenting that should resolve the
> issue.

This is is the most common mistake we see when new people try the hostapd.
hw_mode is misleading to think that valid values are a/b/g/n/ac, its
better to rename it as
a freq_band don't you think?

_______________________________________________
Hostap mailing list
Hostap@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/hostap



[Index of Archives]     [Linux Wireless]     [Linux Kernel]     [ATH6KL]     [Linux Bluetooth]     [Linux Netdev]     [Kernel Newbies]     [IDE]     [Security]     [Git]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Linux ATA RAID]     [Samba]     [Device Mapper]

  Powered by Linux