On Fri, Mar 15, 2024 at 09:09:11PM +0100, Krzysztof Kozlowski wrote: > > +properties: > > + compatible: > > + const: mikrobus-connector > > Hm, why do you create binding for the connector, not for some sort of > controller? Please provide some rationale for this in commit msg. I think you have a distorted view. I refer you to the Mikroe mikroBUS specification - it's _just_ a connector which provides a fairly standardised purpose for each pin and the electrical specifications. For example of the pins: power, UART, SPIs, I2C, PWM, and analogue pins. > > + pinctrl-names: > > + items: > > + - const: default > > + - const: pwm_default > > + - const: pwm_gpio > > + - const: uart_default > > + - const: uart_gpio > > + - const: i2c_default > > + - const: i2c_gpio > > + - const: spi_default > > + - const: spi_gpio > > I fail to see why such choice is related to the connector itself. This isn't a choice at all. Here's the list of pins: Analog - AN Reset - RST SPI Chip Select - CS SPI Clock - SCK SPI Master Input Slave Output - MISO SPI Master Output Slave Input - MOSI VCC-3.3V power - +3.3V Reference Ground - GND PWM - PWM output INT - Hardware Interrupt RX - UART Receive TX - UART Transmit SCL - I2C Clock SDA - I2C Data +5V - VCC-5V power GND - Reference Ground Any data pin can be a GPIO if e.g. a relay board is plugged in, even if some of the other pins are used for e.g. UART purposes. For example, a GPS board that provides the GPS data over the UART pins, and the PPS signal through a different pin. -- RMK's Patch system: https://www.armlinux.org.uk/developer/patches/ FTTP is here! 80Mbps down 10Mbps up. Decent connectivity at last! _______________________________________________ greybus-dev mailing list -- greybus-dev@xxxxxxxxxxxxxxxx To unsubscribe send an email to greybus-dev-leave@xxxxxxxxxxxxxxxx
|