On Thu, Jan 10, 2019 at 11:21:04PM +0530, Nishad Kamdar wrote:
> Use the gpiod interface instead of the deprecated old non-descriptor
> interface while continuing to ignore gpio flags from device tree in
> functions "deassert_reset()" and "assert_reset()" for now.
>
> Signed-off-by: Nishad Kamdar <nishadkamdar@xxxxxxxxx>
> ---
> Changes in v5:
> - Change the commit message.
> - Restore the names of the gpio device-tree properties without
> the "-gpio" suffix.
> Changes in v4:
> - Use gpiod_set_raw_value() for deassert_reset() and
> assert_reset() as gpiod_set_value() will change the
> sematics of these calls by taking any gpio flags
> into account.
> - Remove some unnecesssary line breaks.
> - Restore 'spi_en' gpio check in fw_flashing_seq()
> as it is currently optional.
> Changes in v3:
> - Add this patch in a patchset.
> Changes in v2:
> - Resolved compilation errors.
> ---
Also looks good now. You can add my
Reviewed-by: Johan Hovold <johan@xxxxxxxxxx>
Found one really minor nit below, which doesn't really need to be fixed,
but since you may need to update the third patch, you might as well
consider this too.
> /* It's not mandatory to support power management interface */
> - apb->pwroff_gpio = of_get_named_gpio(np, "pwr-off-gpios", 0);
> - if (apb->pwroff_gpio < 0) {
> - dev_err(dev, "failed to get power off gpio\n");
> - return apb->pwroff_gpio;
> - }
> - ret = devm_gpio_request_one(dev, apb->pwroff_gpio,
> - GPIOF_IN, "pwroff_n");
> - if (ret) {
> - dev_err(dev, "Failed requesting pwroff_n gpio %d\n",
> - apb->pwroff_gpio);
> + apb->pwroff = devm_gpiod_get_optional(dev, "pwr-off",
> + GPIOD_IN);
Looks like you don't need to break the above statement any more either.
> + if (IS_ERR(apb->pwroff)) {
> + ret = PTR_ERR(apb->pwroff);
> + dev_err(dev, "Failed requesting pwroff_n GPIO: %d\n", ret);
> return ret;
> }
>
> /* Do not make clock mandatory as of now (for DB3) */
> - apb->clk_en_gpio = of_get_named_gpio(np, "clock-en-gpio", 0);
> - if (apb->clk_en_gpio < 0) {
> - dev_warn(dev, "failed to get clock en gpio\n");
> - } else if (gpio_is_valid(apb->clk_en_gpio)) {
> - ret = devm_gpio_request_one(dev, apb->clk_en_gpio,
> - GPIOF_OUT_INIT_LOW, "apb_clk_en");
> - if (ret) {
> - dev_warn(dev, "Failed requesting APB clock en gpio %d\n",
> - apb->clk_en_gpio);
> - return ret;
> - }
> + apb->clk_en = devm_gpiod_get_optional(dev, "clock-en",
> + GPIOD_OUT_LOW);
Same here?
> + if (IS_ERR(apb->clk_en)) {
> + ret = PTR_ERR(apb->clk_en);
> + dev_err(dev, "Failed requesting APB clock en GPIO: %d\n", ret);
> + return ret;
> }
Johan
_______________________________________________
greybus-dev mailing list
greybus-dev@xxxxxxxxxxxxxxxx
https://lists.linaro.org/mailman/listinfo/greybus-dev
|