That's intriguing. I'll check this out. ----- Original Message ----- From: "Nyamul Hassaan" <mnhassan@xxxxxxx> Sent: Sunday, February 25, 2007 10:59 PM Hi, When I enable Capacity Control in both version 2.2.4 and 2.2.5, and specify that some of the IPs capacities be controlled, it seems that the calls from all IPs are getting returned with error 34 (no circuit available) from the gk itself (%r is 0). My config is as follows: [Gatekeeper::Auth] FileIPAuth=required;GRQ,LRQ,RRQ,Setup CapacityControl=required;Setup [FileIPAuth] 192.168.1.1=allow 192.168.2.1=allow any=reject [Gatekeepr::Acct] FileAcct=required;stop StatusAcct=required;stop CapacityControl=required;start,stop [CapacityControl] %r010101% ip:192.168.1.1=120 %r010101% ip:192.168.2.1=90 ip:any=1000 Even when the total call count in the GK is below 90 calls, and I have permanent endpoints registered with over 600 channels, I am getting error 34 from not only IPs mentioned in the CapacityControl section, but also from other customers. Is there something that I am missing here? Or is this a bug? Regards HASSAAN ------------------------------------------------------------------------- Take Surveys. Earn Cash. Influence the Future of IT Join SourceForge.net's Techsay panel and you'll get the chance to share your opinions on IT & business topics through brief surveys-and earn cash http://www.techsay.com/default.php?page=join.php&p=sourceforge&CID=DEVDEV _______________________________________________________ Posting: mailto:Openh323gk-users@xxxxxxxxxxxxxxxxxxxxx Archive: http://sourceforge.net/mailarchive/forum.php?forum_id=8549 Unsubscribe: http://lists.sourceforge.net/lists/listinfo/openh323gk-users Homepage: http://www.gnugk.org/
