Hi
List,
I colleague has
installed gnugk (v2.2.2) and the "debug trc" does not work as I have observed
with earlier versions (v2.03)
with earlier
versions
After entering "
debug trc 5"
gnugk responds with "Trace Level is now 5" but all I get is that standard one liner LCF, ARQ, ACF debug out.
gnugk responds with "Trace Level is now 5" but all I get is that standard one liner LCF, ARQ, ACF debug out.
e.g.
debug trc 5
Trace Level is now 5
Trace Level is now 5
LCF|202.89.x.y|1826_endp|09916xxxx:dialedDigits|202.89.x.y;
< and nothing
more >
I was expecting full
contents of each message to be displayed (as I have previously
observed).
Has the way you use
debug trc changed or is there some other component or config setting that
effects the output of "debug trc"?
Regards
Mark
