Well shiver me timbers. I just noticed that I was using OpenH323GK 2.2 beta, wherein I thought it was 2.0.6. I switched to 2.0.7 & viola, it works fine. Sorry about that. -g On Fri, 2004-01-23 at 12:00, Glen wrote: > >> Could you post full config of Cisco gateways plus output of gnugk > console for "??" command? > > Sure! > I changed some of the ip addresses & numbers, & but everything else is > pretty much the same. > > > ?? Output: > > AllRegistrations > RCF|10.10.1.10:1720|drbunsen:h323_ID|gateway|9109_endp > Fri, 23 Jan 2004 11:55:33 -0500 (permanent) C(0/1/1) <1> > Prefixes: 954 > RCF|10.10.2.10:1720|pepe:h323_ID|gateway|9110_endp > Fri, 23 Jan 2004 11:55:07 -0500 (permanent) C(0/1/1) <1> > Prefixes: <none> > Number of Endpoints: 2 > > > Pepe config (source gateway): > > version 12.2 > service timestamps debug uptime > service timestamps log uptime > service password-encryption > ! > hostname pepe > ! > enable secret 5 $1$50Ps$xOtmk5o5Ou7adIMLR3ITj/ > ! > username paul password 7 1415000E0D0F7E7B75 > ! > ! > resource-pool disable > ! > call rsvp-sync > ip subnet-zero > ! > isdn switch-type primary-ni > ! > voice service pots > ! > ! > ! > ! > ! > fax interface-type modem > mta receive maximum-recipients 0 > ! > controller T1 0 > framing esf > clock source line primary > linecode b8zs > pri-group timeslots 1-24 > description "IDS Input #1 PRI (1234)" > ! > controller T1 1 > framing sf > clock source line secondary 1 > linecode ami > ! > controller T1 2 > framing sf > linecode ami > ! > controller T1 3 > framing sf > linecode ami > ! > translation-rule 10 > Rule 0 1234 3456 > ! > ! > ! > interface Ethernet0 > no ip address > shutdown > ! > interface Serial0:23 > no ip address > isdn switch-type primary-ni > isdn incoming-voice modem > no cdp enable > ! > interface FastEthernet0 > ip address 10.10.2.10 255.255.255.240 > duplex full > speed 100 > h323-gateway voip interface > h323-gateway voip id OpenH323GK ipaddr 10.10.0.10 1719 > h323-gateway voip h323-id pepe > ! > ip classless > ip route 0.0.0.0 0.0.0.0 10.10.2.1 > no ip http server > ip pim bidir-enable > ! > ! > ! > voice-port 0:D > ! > dial-peer voice 1 pots > incoming called-number 1234 > no digit-strip > direct-inward-dial > port 0:D > ! > dial-peer voice 3 voip > destination-pattern 1234 > translate-outgoing called 10 > session target ras > no vad > ! > gateway > ! > ! > line con 0 > line aux 0 > line vty 0 4 > password 7 045919030E2A181E58 > login > ! > end > > > > DrBunsen config (dest gateway): > > version 12.2 > service timestamps debug datetime msec > service timestamps log datetime msec > service password-encryption > ! > hostname drbunsen > ! > logging queue-limit 100 > enable secret 5 $1$ZpWI$qVg.QHacTb50aQrjrwEA.1 > ! > username paul password 7 045919030E2A181E58 > ! > ! > resource-pool disable > clock timezone EST -4 > ! > ip subnet-zero > ip domain name diversehost.net > ip name-server 63.126.131.200 > ip name-server 65.198.195.100 > ! > ! > isdn switch-type primary-ni > ! > ! > voice service pots > ! > ! > ! > ! > ! > ! > ! > no voice hpi capture buffer > no voice hpi capture destination > ! > ! > mta receive maximum-recipients 0 > ! > ! > controller T1 0 > framing esf > clock source line primary > linecode b8zs > pri-group timeslots 1-24 > description "IDS Input #2 PRI (5678)" > ! > controller T1 1 > framing esf > linecode b8zs > ds0-group 0 timeslots 1-24 type e&m-fgb dtmf dnis > cas-custom 0 > description "STX 19-5" > ! > controller T1 2 > shutdown > framing sf > linecode ami > ! > controller T1 3 > framing esf > linecode b8zs > ds0-group 0 timeslots 1-24 type e&m-fgb dtmf dnis > cas-custom 0 > gw-accounting aaa > ! > ! > ! > interface Ethernet0 > no ip address > shutdown > ! > interface Serial0 > no ip address > shutdown > clockrate 2015232 > no fair-queue > ! > interface Serial1 > no ip address > shutdown > clockrate 2015232 > no fair-queue > ! > interface Serial2 > no ip address > shutdown > clockrate 2015232 > no fair-queue > ! > interface Serial3 > no ip address > shutdown > clockrate 2015232 > no fair-queue > ! > interface Serial0:23 > no ip address > no logging event link-status > isdn switch-type primary-ni > isdn incoming-voice modem > no keepalive > no cdp enable > ! > interface FastEthernet0 > ip address 10.10.1.10 255.255.255.0 > duplex full > speed 100 > h323-gateway voip interface > h323-gateway voip id OpenH323GK ipaddr 10.10.0.10 1719 > h323-gateway voip h323-id drbunsen > ! > ip default-gateway 10.10.1.1 > ip classless > ip route 0.0.0.0 0.0.0.0 10.10.1.1 > ip route 10.10.10.0 255.255.255.0 10.10.11.1 > no ip http server > ! > ! > call rsvp-sync > ! > ! > voice-port 0:D > ! > voice-port 1:0 > ! > voice-port 3:0 > ! > ! > mgcp profile default > ! > dial-peer cor custom > ! > ! > dial-peer voice 3 pots > incoming called-number 3456 > direct-inward-dial > port 1:0 > ! > gateway > ! > banner motd C > You are not authorized to connect to this device > Please discconect now. > > ! > line con 0 > logging synchronous > line aux 0 > line vty 0 4 > password 7 130705170A07507A7A > logging synchronous > login > line vty 5 999 > password 7 061C0E2C4E410710 > logging synchronous > login > ! > end > > > > > On Fri, 2004-01-23 at 02:23, Julius wrote: > > Hi, > > > > Could you post full config of Cisco gateways plus output of gnugk > > console for "??" command? > > > > Julius > > > > > > On Thu, 2004-01-22 at 20:21, Glen wrote: > > > I have yet to have gnugk working between two cisco gateways. > > > > > > Gw 1 (pepe): > > > h323-gateway voip interface > > > h323-gateway voip id OpenH323GK ipaddr 10.10.10.5 1719 > > > h323-gateway voip h323-id pepe > > > > > > Gw 2 (drbunsen): > > > h323-gateway voip interface > > > h323-gateway voip id OpenH323GK ipaddr 10.10.10.5 1719 > > > h323-gateway voip h323-id drbunsen > > > > > > gnugk prefix config: > > > > > > [RasSrv::GWPrefixes] > > > drbunsen=88 > > > > > > I have a call being forwarded from pepe to drbunsen with the 88 prefix, but debug ras (on drbunsen) shows > > > Jan 22 16:57:35.085: ACF (seq# 7090) rcvdparse_acf_nonstd: asn decoding error -13h323chan_dgram_send:Sent UDP msg. Bytes sent: 3 to 10.10.10.5:1719 fd=2 > > > > > > With debug dialpeer, I see the following on drbunsen (destination gw) > > > Jan 22 18:13:22.453: dpAssociateIncomingPeer_T null source route label > > > > > > No idea what that means. > > > > > > The calls work when the session target ipv4: syntax is used, but not with gnugk. > > > > > > > > > Ideas? > > > > > > -g > > > > > > > > > > > > > > > ------------------------------------------------------- > > > The SF.Net email is sponsored by EclipseCon 2004 > > > Premiere Conference on Open Tools Development and Integration > > > See the breadth of Eclipse activity. February 3-5 in Anaheim, CA. > > > http://www.eclipsecon.org/osdn > > > _______________________________________________ > > > List: Openh323gk-users@lists.sourceforge.net > > > Archive: http://sourceforge.net/mailarchive/forum.php?forum_id=8549 > > > Homepage: http://www.gnugk.org/ > > > > > > > > ------------------------------------------------------- > > The SF.Net email is sponsored by EclipseCon 2004 > > Premiere Conference on Open Tools Development and Integration > > See the breadth of Eclipse activity. February 3-5 in Anaheim, CA. > > http://www.eclipsecon.org/osdn > > _______________________________________________ > > List: Openh323gk-users@lists.sourceforge.net > > Archive: http://sourceforge.net/mailarchive/forum.php?forum_id=8549 > > Homepage: http://www.gnugk.org/ > > > > ------------------------------------------------------- > The SF.Net email is sponsored by EclipseCon 2004 > Premiere Conference on Open Tools Development and Integration > See the breadth of Eclipse activity. February 3-5 in Anaheim, CA. > http://www.eclipsecon.org/osdn > _______________________________________________ > List: Openh323gk-users@lists.sourceforge.net > Archive: http://sourceforge.net/mailarchive/forum.php?forum_id=8549 > Homepage: http://www.gnugk.org/ ------------------------------------------------------- The SF.Net email is sponsored by EclipseCon 2004 Premiere Conference on Open Tools Development and Integration See the breadth of Eclipse activity. February 3-5 in Anaheim, CA. http://www.eclipsecon.org/osdn _______________________________________________ List: Openh323gk-users@lists.sourceforge.net Archive: http://sourceforge.net/mailarchive/forum.php?forum_id=8549 Homepage: http://www.gnugk.org/
