The gk 2.2 addresses this issue - it uses multithreaded RAS handling and RADIUS modules are already designed in such way that allows efficient usage from multiple threads. ----- Original Message ----- From: "Daniel Liu" <daniel.liu@cu88.com> Sent: Wednesday, January 21, 2004 5:54 AM > Do you use radauth and radacct? > I had this problem before too.But I do not know if it is the same as yours. > I have setup gnugk with radauth and radacct.I found sometimes gnugk stop > responding ARQ request.There are only RCF/RRJ messages in status port. > And I found there are so many packets waiting gnugk to do(try netstat -na -u). > Then I try to reduce radius request timeout value to 50ms.It is ok now. > gnugk v2.0.x is using one thread to carry with RAS message.The auth module will > block the thread. We must change to use multithread or asynchronous auth module interface. > Am I right? > Best regards, > Daniel > > Artem Klyuka write: > > > Hello All > > I installed GnuGK recenly and have some problem > > 1) I make call > > Phone -> Cisco 1751 -> GnuGK - > termination gateway .. :) > > i make one call, immediately make othet .. > > All is ok . > > But .. very often .. after making few sucessful calls .. i can't make a call > > .. > > I even don't see any call request in GnuGK log .. > > But if i restart GnuGK .. all begen to work immediately .. > > on my cisco - i get " no route to destination " - and any responce from > > GnuGK .. > > so while i have problem like this .. i can' tuse GK normally .. ------------------------------------------------------- The SF.Net email is sponsored by EclipseCon 2004 Premiere Conference on Open Tools Development and Integration See the breadth of Eclipse activity. February 3-5 in Anaheim, CA. http://www.eclipsecon.org/osdn _______________________________________________ List: Openh323gk-users@lists.sourceforge.net Archive: http://sourceforge.net/mailarchive/forum.php?forum_id=8549 Homepage: http://www.gnugk.org/
