As far as I know gnugk sends Accounting-Start to radius on arq reception. It may take some time before the callee picks up, or even if doesn't, but when a call is terminated a way to determin its duration is to use Acct-SessionTime - it is *exactly* the time of active connection. If call wasn't initiated - it's probably set to 0. Or you may look at h323-disconnect-cause values also sent to radius. > Hi guys i can make the cisco to give a signal about this situation: > > i call from and ata my gateways is a cisco 3620 ...all is ok ..when a > put a call through the gateways it make the call ..but if the other end > do not pick up the phone the gk sendme a time of connection to the > billing system... and this is untrue...anybody have experience how to > configure the gk or the cisco so onlЯy send me a true connection??? > > i compare the h323-setup-time the connect-time and the disconnect-time > and always have values ....similar values ...with that error...how can > you determine that the other party pick-up the phone??? > Thank You. > > > > ------------------------------------------------------- > The SF.Net email is sponsored by EclipseCon 2004 > Premiere Conference on Open Tools Development and Integration > See the breadth of Eclipse activity. February 3-5 in Anaheim, CA. > http://www.eclipsecon.org/osdn > _______________________________________________ > List: Openh323gk-users@lists.sourceforge.net > Archive: http://sourceforge.net/mailarchive/forum.php?forum_id 49 > Homepage: http://www.gnugk.org/ > ------------------------------------------------------- The SF.Net email is sponsored by EclipseCon 2004 Premiere Conference on Open Tools Development and Integration See the breadth of Eclipse activity. February 3-5 in Anaheim, CA. http://www.eclipsecon.org/osdn _______________________________________________ List: Openh323gk-users@lists.sourceforge.net Archive: http://sourceforge.net/mailarchive/forum.php?forum_id=8549 Homepage: http://www.gnugk.org/
