Thanks a lot for this info. I'll give it a shot.
----- Original Message ----- From: "Simon Kitching" <skitching@xxxxxxxxxx>
To: "Allyn Baskerville" <allynb@xxxxxxxxx>
Cc: <gnome-list@xxxxxxxxx>
Sent: Saturday, February 19, 2005 3:18 PM
Subject: Re: GUI does not load after monitor is changed
On Sat, 2005-02-19 at 08:09 -0600, Allyn Baskerville wrote:I suspect this has been asked several times as it's happened to me a couple of times, but I didn't see the solution in the archives.
I have RH RC2 installed on an old Compaq 800 ProLiant. After the machine was built, I moved it to a rack with a KVM and a different
monitor installed. I could tell the GUI keeps trying to load but fails. I suspect the machine doesn't recognize the monitor. I tried
to change /etc/X11/XF86config, but it hasn't helped at this point. Do I need to try something else, or should this file be the
culprit? Thanks - Allyn
Have you tried running this? dpkg-reconfigure xserver-xfree86
That will take you through the original install setup questions for X, then generate a new XF86config file.
You might want to back up the original one before doing this.
NB: This is just a guess. No promises this will fix your problem..
Cheers,
Simon
_______________________________________________ gnome-list mailing list gnome-list@xxxxxxxxx http://mail.gnome.org/mailman/listinfo/gnome-list
