On Wed, 2015-08-12 at 17:09 +0530, Ravishankar N wrote: > > On 08/11/2015 10:06 PM, Kingsley wrote: > > Hi, > > > > If you need to reboot all bricks in a volume, what's the best way to do > > this seamlessly? > > > > I did this a few days ago by rebooting one, then waiting for "gluster > > volume info" on another brick to show it back online before doing the > > next, and so on. However, it went a bit wrong and I ended up with a > > corruption. It fixed itself after a while, but because the system then > > had a backlog of stuff to catch up with, it didn't fix itself for about > > a day. > > > > I wonder that I didn't leave enough time for the freshly rebooted brick > > to apply all of the updates to itself that happened while it was > > rebooting. So, what's the best way to find out whether a brick has fully > > synced itself with the other bricks, before rebooting the next one? > > 'gluster volume heal <volname> info` must show zero entries. If it > doesn't, you can manually launch self heal by 'gluster volume heal > <volname>` Thanks for that, Ravi, that's very useful to know. I did try the volume heal, but I couldn't see how to figure out how far it had got in percentage terms. Is there a command that I can issue that gives an indication of how far through the heal process has got, eg "healed 370 or 1022 objects"? -- Cheers, Kingsley. _______________________________________________ Gluster-users mailing list Gluster-users@xxxxxxxxxxx http://www.gluster.org/mailman/listinfo/gluster-users