----- Original Message ----- > From: "Suneel Gali" <suneelgali@xxxxxxxxxxx> > To: "Rajesh Joseph" <rjoseph@xxxxxxxxxx>, gluster-users@xxxxxxxxxxx > Sent: Friday, June 19, 2015 5:58:40 PM > Subject: RE: snapshot create: failed: Snapshot is supported only for thin provisioned LV. Ensure that > all bricks of replvol are thinly provisioned LV. > > Hi Rajesh, > > LUKS is not in use. > > Disabling SELinux on all the nodes helped. Thanks for the info. > > Do you have any ETA for the fix? SELinux fix should come as SELinux policies. Currently I don't have an ETA for this. Will update you once we complete RCA on all open SELinux issues. > > Regards, > Suneel > > > Date: Fri, 19 Jun 2015 04:39:15 -0400 > > From: rjoseph@xxxxxxxxxx > > To: suneelgali@xxxxxxxxxxx > > CC: gluster-users@xxxxxxxxxxx > > Subject: Re: snapshot create: failed: Snapshot is supported > > only for thin provisioned LV. Ensure that all bricks of replvol are thinly > > provisioned LV. > > > > > > > > ----- Original Message ----- > > > From: "Suneel Gali" <suneelgali@xxxxxxxxxxx> > > > To: gluster-users@xxxxxxxxxxx > > > Sent: Thursday, June 18, 2015 7:52:41 PM > > > Subject: snapshot create: failed: Snapshot is supported > > > only for thin provisioned LV. Ensure that all > > > bricks of replvol are thinly provisioned LV. > > > > > > Hi Team, > > > > > > Snapshot creation is failing with the error: > > > > > > "snapshot create: failed: Snapshot is supported only for thin provisioned > > > LV. > > > Ensure that all bricks of replvol are thinly provisioned LV." > > > > > > > > > > > > > > > Gluster/OS Versions: > > > > > > > > > > > > > > > output of: gluster volume info replvol: > > > > > > > > > > > > All the bricks are created from thin pools: > > > > > > > > > > > > > > > > > > I see there is a open defect ( Bug 1178031 - [SNAPSHOT]: fails to create > > > on > > > thin LV with LUKS layer in between ) with similar failure message. I am > > > not > > > sure it is same. > > > > > > Are you using LUKS along with LVM? This bug was not taken up yet, but we > > will > > prioritize this for next release. > > > > If not just check that SELinux is enabled in your system. Currently > > snapshot has > > known issue with SELinux. If that is the case then disable SELinux and run > > snapshot create again. > > > > > > > > PFA logs from gluster02 (where I ran snapshot create command). > > > > > > Any suggestions will be helpful. > > > > > > > > > Regards, > > > Suneel > > > > > > > > > _______________________________________________ > > > Gluster-users mailing list > > > Gluster-users@xxxxxxxxxxx > > > http://www.gluster.org/mailman/listinfo/gluster-users > _______________________________________________ Gluster-users mailing list Gluster-users@xxxxxxxxxxx http://www.gluster.org/mailman/listinfo/gluster-users
