Hello,
thanks for helping :)
If gluster server is rebooted, any way to make client failback on node after reboot ?
How to know which node is using a client ? I see TCP connection to both node
Regards,
2015-05-11 7:13 GMT+02:00 Ravishankar N <ravishankar@xxxxxxxxxx>:
On 05/10/2015 08:29 PM, Mathieu Chateau wrote:
Hello,
Short way: Is there any way to define a preferred Gluster server ?
Long way:I have the following setup (version 3.6.3) :
Gluster A <==> VPN <==> Gluster B
Volume is replicated between A and B.
They are in same datacenter, using a 1Gb/s connection, low latency (0.5ms)
I have gluster clients in lan A & B.
When doing a "ls" on big folder (~60k files), both gluster node are used, and so it need 9mn instead on 1mn if only the local gluster is reachable.
Lookups (and writes of course) from clients are sent to both bricks because AFR uses the result of the lookup to select which brick to read from if there is a pending heal etc.
If the file is clean on both A and B, then reads are always served from the local brick. i.e. reads on clients mounted on A will be served from the brick in A (and likewise for B).
Hope that helps,
Ravi
It's HA setup, application is present on both side. I would like a master/master setup, but using only local node as possible.
_______________________________________________ Gluster-users mailing list Gluster-users@xxxxxxxxxxx http://www.gluster.org/mailman/listinfo/gluster-users
_______________________________________________ Gluster-users mailing list Gluster-users@xxxxxxxxxxx http://www.gluster.org/mailman/listinfo/gluster-users
