The change actually adds only (e.g. `%C(auto,red)`) but reflowing the paragraph blows it up a little. -------- 8< -------- The manual correctly describes the syntax with `auto,` but the trailing `,` is hard to spot in a terminal. The HTML format does not have this problem. Adding an example helps both worlds. Signed-off-by: Andreas Heiduk <asheiduk@xxxxxxxxx> --- Documentation/pretty-formats.txt | 11 ++++++----- 1 file changed, 6 insertions(+), 5 deletions(-) diff --git a/Documentation/pretty-formats.txt b/Documentation/pretty-formats.txt index 38040e95b..b03985101 100644 --- a/Documentation/pretty-formats.txt +++ b/Documentation/pretty-formats.txt @@ -174,11 +174,12 @@ endif::git-rev-list[] - '%Creset': reset color - '%C(...)': color specification, as described under Values in the "CONFIGURATION FILE" section of linkgit:git-config[1]; - adding `auto,` at the beginning will emit color only when colors are - enabled for log output (by `color.diff`, `color.ui`, or `--color`, and - respecting the `auto` settings of the former if we are going to a - terminal). `auto` alone (i.e. `%C(auto)`) will turn on auto coloring - on the next placeholders until the color is switched again. + adding `auto,` at the beginning (e.g. `%C(auto,red)`) will emit + color only when colors are enabled for log output (by `color.diff`, + `color.ui`, or `--color`, and respecting the `auto` settings of the + former if we are going to a terminal). `auto` alone (i.e. + `%C(auto)`) will turn on auto coloring on the next placeholders + until the color is switched again. - '%m': left (`<`), right (`>`) or boundary (`-`) mark - '%n': newline - '%%': a raw '%' -- 2.13.1
