Hi,
Yes, I'm using Windows.
I've got the file--where do I put it?
Cheers,
Chris
Owen Cook wrote:
On Sun, 11 Dec 2005, Chris Share wrote:
I'm getting the following error when I run CompileGIMPShellScript.sh:
checking for GLIB - version >= 2.8.0... no
*** Could not run GLIB test program, checking why...
*** The test program failed to compile or link. See the file config.log
for the
*** exact error that occured. This usually means GLIB is incorrectly
installed.
configure: error: Test for GLIB failed. See the file 'INSTALL' for help.
OK. Script is finished now.
I suspect that the error is because I don't have the correct version of
GLIB.
What libraries do I need to fix this and where do I put them?
Your suspicions are correct and as the program is looking for
GLIB - version >= 2.8.0 I guess you best install glib-2.8 or better
glib-2.8.4.tar.bz2 is probably the one you are after, found at
http://www.gtk.org or direct thru ftp://ftp.gtk.org/pub/gtk/v2.8/
You don't say, but if you are using Windows, then the above advice may not
apply.
I surprised gtk-2.8 went on without glib-2.8
Owen
_______________________________________________
Gimp-developer mailing list
Gimp-developer@xxxxxxxxxxxxxxxxxxxxxx
https://lists.XCF.Berkeley.EDU/mailman/listinfo/gimp-developer
_______________________________________________
Gimp-developer mailing list
Gimp-developer@xxxxxxxxxxxxxxxxxxxxxx
https://lists.XCF.Berkeley.EDU/mailman/listinfo/gimp-developer
