On Sun, 11 Dec 2005, Chris Share wrote: > > I'm getting the following error when I run CompileGIMPShellScript.sh: > > > checking for GLIB - version >= 2.8.0... no > *** Could not run GLIB test program, checking why... > *** The test program failed to compile or link. See the file config.log > for the > *** exact error that occured. This usually means GLIB is incorrectly > installed. > configure: error: Test for GLIB failed. See the file 'INSTALL' for help. > OK. Script is finished now. > > > I suspect that the error is because I don't have the correct version of > GLIB. > > What libraries do I need to fix this and where do I put them? Your suspicions are correct and as the program is looking for GLIB - version >= 2.8.0 I guess you best install glib-2.8 or better glib-2.8.4.tar.bz2 is probably the one you are after, found at http://www.gtk.org or direct thru ftp://ftp.gtk.org/pub/gtk/v2.8/ You don't say, but if you are using Windows, then the above advice may not apply. I surprised gtk-2.8 went on without glib-2.8 Owen _______________________________________________ Gimp-developer mailing list Gimp-developer@xxxxxxxxxxxxxxxxxxxxxx https://lists.XCF.Berkeley.EDU/mailman/listinfo/gimp-developer
