Has the X11.conf changed between FC3 and FC4 T2? On my FC3 machine I have an ATI 9200 and on the machine I want to try FC4 T2 it has only a 32M VIA unichrome (S3) on board. The monitor is a Samsung SyncMaster 192N which was properly recognized by FC4 (not FC3) through a KVM. The maximum frequency for this LCD is 60Hz. The install went fine when I set the resolution=1280x1024 but then wouldn't boot into X. I modified the some of the settings for the horizontal and vertical syncing to a) the manual listed settings, and b) the settings in my FC3 X11.conf For the resolution, initially there was only 800x600 and 640x480 in the FC4_T2 X11.conf, so added a "1024x768" resolution. I haven't tried to add the 1280x1024 resolution to the conf file yet. I can boot into single user mode to make these changes but not into X. I could pick up a cheap 64M ATI Radeon 9250 to see if it works but if I can avoid it I'd prefer it. Anything else I can try? Thanks, Dave PS: mediacheck failed but install worked great.