Hi, from a term (as root) just type hal-device-manager & Actually I don't think you need to be root :-) That will open a window with a tree view on the left and a tabbed panel on the right. Open the nodes on the left until you see your PC Cardbus (if you have two slots there are probably two) open those up and find the Intersil ... then on the right click on the advanced tab - that will list all the properties of the card. hal-device-manager is a nice hw inspection GUI. Andrew > -----Original Message----- > From: Neil Gierman [mailto:ngierman@xxxxxxxxxxxx] > Sent: Friday, October 22, 2004 02:52 PM > To: ''For testers of Fedora Core development releases'' > Subject: RE: Prism54 firmware load failure only during boot > > This happens in both 2.6.8-1.541 and 2.6.9-1.640 > > However in FC2 with both 2.6.5-1.358 and 2.6.8-1.521 it would load just fine > after PCMCIA started > > In /var/log/messages I do see the failed firmware upload attempts but no > corresponding udev entries: > ..... > Oct 22 08:39:58 m700 kernel: IA-32 Microcode Update Driver: v1.14 > <tigran@xxxxxxxxxxx> <snip> > > I have not tried to remove and reinsert the hardware itself after boot, but > I might try that when I get back home tonight. > > I'm a bit new to the hotplug/hal environment myself, could you point me in > the right direction to find the hal-device-manager advanced properties? >