Hi,
is there anything else I need to do, or can this patch now be applied?
The initial two patches that introduce property support have already
been merged, and the patch series that this patch depends on [1] has
also been applied.
[1] https://lore.kernel.org/all/Z7rZjdXwN2W+Y2Bd@dragon/
Best regards,
Andrej
On 16. 12. 24 09:54, Andrej Picej wrote:
Set custom differential output voltage for LVDS, to fulfill requirements
of the connected display. LVDS differential voltage for data-lanes and
clock output has to be between 200 mV and 600 mV.
Driver sets 200 Ohm near-end termination by default.
Signed-off-by: Andrej Picej <andrej.picej@xxxxxxxxx>
---
Changes in v7:
- no change
Changes in v6:
- no change
Changes in v5:
- no change
Changes in v4:
- no change
Changes in v3:
- no change
Changes in v2:
- use new properties from previous patches
---
.../boot/dts/freescale/imx8mm-phyboard-polis-peb-av-10.dtso | 2 ++
1 file changed, 2 insertions(+)
diff --git a/arch/arm64/boot/dts/freescale/imx8mm-phyboard-polis-peb-av-10.dtso b/arch/arm64/boot/dts/freescale/imx8mm-phyboard-polis-peb-av-10.dtso
index a9de42cf14be..8bf9cc553bea 100644
--- a/arch/arm64/boot/dts/freescale/imx8mm-phyboard-polis-peb-av-10.dtso
+++ b/arch/arm64/boot/dts/freescale/imx8mm-phyboard-polis-peb-av-10.dtso
@@ -186,6 +186,8 @@ port@2 {
reg = <2>;
bridge_out: endpoint {
remote-endpoint = <&panel_in>;
+ ti,lvds-vod-swing-clock-microvolt = <200000 600000>;
+ ti,lvds-vod-swing-data-microvolt = <200000 600000>;
};
};
};
