On chipsets such as QCS615, there is no 3dmux present. In such
a case, a layer exceeding the max_mixer_width cannot be split,
hence cannot be supported.
Filter out the modes which exceed the max_mixer_width when there
is no 3dmux present. Also, add a check in the dpu_crtc_atomic_check()
to return failure for such modes.
Signed-off-by: Abhinav Kumar <quic_abhinavk@xxxxxxxxxxx>
---
Note: this was only compile tested, so its pending validation on QCS615
---
drivers/gpu/drm/msm/disp/dpu1/dpu_crtc.c | 13 +++++++++++++
1 file changed, 13 insertions(+)
diff --git a/drivers/gpu/drm/msm/disp/dpu1/dpu_crtc.c b/drivers/gpu/drm/msm/disp/dpu1/dpu_crtc.c
index 9f6ffd344693ecfb633095772a31ada5613345dc..e6e5540aae83be7c20d8ae29115b8fdd42056e55 100644
--- a/drivers/gpu/drm/msm/disp/dpu1/dpu_crtc.c
+++ b/drivers/gpu/drm/msm/disp/dpu1/dpu_crtc.c
@@ -732,6 +732,13 @@ static int _dpu_crtc_check_and_setup_lm_bounds(struct drm_crtc *crtc,
struct dpu_kms *dpu_kms = _dpu_crtc_get_kms(crtc);
int i;
+ /* if we cannot merge 2 LMs (no 3d mux) better to fail earlier
+ * before even checking the width after the split
+ */
+ if (!dpu_kms->catalog->caps->has_3d_merge
+ && adj_mode->hdisplay > dpu_kms->catalog->caps->max_mixer_width)
+ return -E2BIG;
+
for (i = 0; i < cstate->num_mixers; i++) {
struct drm_rect *r = &cstate->lm_bounds[i];
r->x1 = crtc_split_width * i;
@@ -1251,6 +1258,12 @@ static enum drm_mode_status dpu_crtc_mode_valid(struct drm_crtc *crtc,
{
struct dpu_kms *dpu_kms = _dpu_crtc_get_kms(crtc);
+ /* if there is no 3d_mux block we cannot merge LMs so we cannot
+ * split the large layer into 2 LMs, filter out such modes
+ */
+ if (!dpu_kms->catalog->caps->has_3d_merge
+ && mode->hdisplay > dpu_kms->catalog->caps->max_mixer_width)
+ return MODE_BAD;
/*
* max crtc width is equal to the max mixer width * 2 and max height is 4K
*/
---
base-commit: af2ea8ab7a546b430726183458da0a173d331272
change-id: 20241206-no_3dmux-521a55ea0669
Best regards,
--
Abhinav Kumar <quic_abhinavk@xxxxxxxxxxx>
