AUDIO_UPDATE bit (Bit 5 of MAIN register 0x4A) needs to be set to 1
while updating Audio InfoFrame information and then set to 0 when done.
Otherwise partially updated Audio InfoFrames could be sent out. Two
cases where this rule were not followed are fixed:
- In adv7511_hdmi_hw_params() make sure AUDIO_UPDATE bit is updated
before/after setting ADV7511_REG_AUDIO_INFOFRAME.
- In audio_startup() use the correct register for clearing
AUDIO_UPDATE bit.
The problem with corrupted audio infoframes were discovered by letting
a HDMI logic analyser check the output of ADV7535.
Fixes: 53c515befe28 ("drm/bridge: adv7511: Add Audio support")
Signed-off-by: Stefan Ekenberg <stefan.ekenberg@xxxxxxxx>
---
Changes in v2:
- Add Fixes tag
- Link to v1: https://lore.kernel.org/r/20241113-adv7511-audio-info-frame-v1-1-49b368b995a5@xxxxxxxx
---
drivers/gpu/drm/bridge/adv7511/adv7511_audio.c | 14 ++++++++++++--
1 file changed, 12 insertions(+), 2 deletions(-)
diff --git a/drivers/gpu/drm/bridge/adv7511/adv7511_audio.c b/drivers/gpu/drm/bridge/adv7511/adv7511_audio.c
index 61f4a38e7d2bf6905683cbc9e762b28ecc999d05..8f786592143b6c81e5a434768b51508d5e5f3c73 100644
--- a/drivers/gpu/drm/bridge/adv7511/adv7511_audio.c
+++ b/drivers/gpu/drm/bridge/adv7511/adv7511_audio.c
@@ -153,7 +153,16 @@ static int adv7511_hdmi_hw_params(struct device *dev, void *data,
ADV7511_AUDIO_CFG3_LEN_MASK, len);
regmap_update_bits(adv7511->regmap, ADV7511_REG_I2C_FREQ_ID_CFG,
ADV7511_I2C_FREQ_ID_CFG_RATE_MASK, rate << 4);
- regmap_write(adv7511->regmap, 0x73, 0x1);
+
+ /* send current Audio infoframe values while updating */
+ regmap_update_bits(adv7511->regmap, ADV7511_REG_INFOFRAME_UPDATE,
+ BIT(5), BIT(5));
+
+ regmap_write(adv7511->regmap, ADV7511_REG_AUDIO_INFOFRAME(0), 0x1);
+
+ /* use Audio infoframe updated info */
+ regmap_update_bits(adv7511->regmap, ADV7511_REG_INFOFRAME_UPDATE,
+ BIT(5), 0);
return 0;
}
@@ -184,8 +193,9 @@ static int audio_startup(struct device *dev, void *data)
regmap_update_bits(adv7511->regmap, ADV7511_REG_GC(0),
BIT(7) | BIT(6), BIT(7));
/* use Audio infoframe updated info */
- regmap_update_bits(adv7511->regmap, ADV7511_REG_GC(1),
+ regmap_update_bits(adv7511->regmap, ADV7511_REG_INFOFRAME_UPDATE,
BIT(5), 0);
+
/* enable SPDIF receiver */
if (adv7511->audio_source == ADV7511_AUDIO_SOURCE_SPDIF)
regmap_update_bits(adv7511->regmap, ADV7511_REG_AUDIO_CONFIG,
---
base-commit: 59b723cd2adbac2a34fc8e12c74ae26ae45bf230
change-id: 20241108-adv7511-audio-info-frame-54614dd4bf57
Best regards,
--
Stefan Ekenberg <stefan.ekenberg@xxxxxxxx>
