On 10/22/24 7:59 AM, Liu Ying wrote:
[...]
Anyway, I don't think it is necessary to manage the clk_set_rate()
function calls between this driver and mxsfb_kms or lcdif_kms
because "video_pll1" clock rate is supposed to be assigned in DT...
I disagree with this part. I believe the assignment of clock in DT is only a temporary workaround which should be removed. The drivers should be able to figure out and set the clock tree configuration.
I think the clock rate assignment in DT is still needed.
A good reason is that again we need to share one video PLL
between MIPI DSI and LDB display pipelines for i.MX8MP.
You don't really need to share the Video PLL , you can free up e.g. PLL3
and use it for one video output pipeline, and use the Video PLL for the
other video pipeline, and then you get accurate pixel clock in both
pipelines.
The idea is to assign a reasonable PLL clock rate in DT to make
display drivers' life easier, especially for i.MX8MP where LDB,
Samsung MIPI DSI may use a single PLL at the same time.
I would really like to avoid setting arbitrary clock in DT, esp. if it can be avoided. And it surely can be avoided for this simple use case.
... just like I said in patch 1/2, "video_pll1" clock rate needs
to be x2 "media_ldb" clock rate for dual LVDS link mode. Without
an assigned "video_pll1" clock rate in DT, this driver cannot
achieve that.
This is something the LDB driver can infer from DT and configure the clock tree accordingly.
Well, the LDB driver only controls the "ldb" clock rate. It doesn't
magically set the parent "video_pll1" clock's rate to 2x it's rate,
unless the driver gets "video_pll1_out" clock by calling
clk_get_parent() and directly controls the PLL clock rate which
doesn't look neat.
It isn't nice, but it actually may solve this problem, no ?
And, the i.MX8MP LDB + Samsung MIPI DSI case is
not simple considering using one single PLL and display modes
read from EDID.
You could use separate PLLs for each LCDIF scanout engine in such a deployment, I already ran into that, so I am aware of it. That is probably the best way out of such a problem, esp. if accurate pixel clock are the requirement.
I cannot use separate PLLs for the i.MX8MP LDB and Samsung MIPI
DSI display pipelines on i.MX8MP EVK, because the PLLs are limited
resources and we are running out of it. Because LDB needs the pixel
clock and LVDS serial clock to be derived from a same PLL, the only
valid PLLs(see imx8mp_media_disp_pix_sels[] and
imx8mp_media_ldb_sels[]) are "video_pll1_out", "audio_pll2_out",
"sys_pll2_1000m" and "sys_pll1_800m". All are used as either audio
clock or system clocks on i.MX8MP EVK, except "video_pll1_out".
Could you use Video PLL for LDB and PLL3 for DSI then ?
I think this could still be configurable per board, it shouldn't be such
that one board which attempts to showcase everything would prevent other
boards with specific requirements from achieving those.
You probably may use separate PLLs for a particular i.MX8MP platform
with limited features, but not for i.MX8MP EVK which is supposed to
evaluate all SoC features.
Right, that, exactly.
[...]
