Hi Benoit, On Tue, Sep 24, 2013 at 11:29:51AM +0200, Benoit Cousson wrote: > Hi Benoit, > > On 03/09/2013 16:55, Benoit Parrot wrote: > >Hi, > > > >I have not received any feedback on this patch. > >It has been pending since the end of June (first post). > >Can I get an estimate when it will be included/accepted? > > It looks good to me beside a minor comment below. > > Could you just rebase it on my lastest git://git.kernel.org/pub/scm/linux/kernel/git/bcousson/linux-omap-dt.git > for_3.13/dts branch because it conflicts with the cleanup done by > Javier. > I was going to rebase it to your for_3.13/dts branch, but Joel Frenandez has already included this patch as part of his most recent submission. (http://marc.info/?l=devicetree&m=138014654925217&w=2) so I guess there is no need to duplicate the work now. Let me know if this causes any issue. Thanks, Benoit > > > >On Fri, Aug 23, 2013 at 11:13:56AM -0500, Benoit Parrot wrote: > >>Add LCDC device node in DT for am33xx > >>Add LCDC and Panel info in DT for am335x-evm > >> > >>Changes in v3: > >>- rebase to 3.11-rc6 > >> > >>Changes in v2: > >>- remove redundant/unnecessary SoC specific setting in the board dts > >> > >>Signed-off-by: Benoit Parrot <bparrot@xxxxxx> > >>--- > >> arch/arm/boot/dts/am335x-evm.dts | 72 ++++++++++++++++++++++++++++++++++++++ > >> arch/arm/boot/dts/am33xx.dtsi | 9 +++++ > >> 2 files changed, 81 insertions(+) > >> > >>diff --git a/arch/arm/boot/dts/am335x-evm.dts b/arch/arm/boot/dts/am335x-evm.dts > >>index 3aee1a4..b0703f1 100644 > >>--- a/arch/arm/boot/dts/am335x-evm.dts > >>+++ b/arch/arm/boot/dts/am335x-evm.dts > >>@@ -149,6 +149,40 @@ > >> 0x14c (PIN_INPUT_PULLDOWN | MUX_MODE7) > >> >; > >> }; > >>+ > >>+ lcd_pins_s0: lcd_pins_s0 { > >>+ pinctrl-single,pins = < > >>+ 0x20 0x01 /* gpmc_ad8.lcd_data16, OUTPUT | MODE1 */ > >>+ 0x24 0x01 /* gpmc_ad9.lcd_data17, OUTPUT | MODE1 */ > >>+ 0x28 0x01 /* gpmc_ad10.lcd_data18, OUTPUT | MODE1 */ > >>+ 0x2c 0x01 /* gpmc_ad11.lcd_data19, OUTPUT | MODE1 */ > >>+ 0x30 0x01 /* gpmc_ad12.lcd_data20, OUTPUT | MODE1 */ > >>+ 0x34 0x01 /* gpmc_ad13.lcd_data21, OUTPUT | MODE1 */ > >>+ 0x38 0x01 /* gpmc_ad14.lcd_data22, OUTPUT | MODE1 */ > >>+ 0x3c 0x01 /* gpmc_ad15.lcd_data23, OUTPUT | MODE1 */ > >>+ 0xa0 0x00 /* lcd_data0.lcd_data0, OUTPUT | MODE0 */ > >>+ 0xa4 0x00 /* lcd_data1.lcd_data1, OUTPUT | MODE0 */ > >>+ 0xa8 0x00 /* lcd_data2.lcd_data2, OUTPUT | MODE0 */ > >>+ 0xac 0x00 /* lcd_data3.lcd_data3, OUTPUT | MODE0 */ > >>+ 0xb0 0x00 /* lcd_data4.lcd_data4, OUTPUT | MODE0 */ > >>+ 0xb4 0x00 /* lcd_data5.lcd_data5, OUTPUT | MODE0 */ > >>+ 0xb8 0x00 /* lcd_data6.lcd_data6, OUTPUT | MODE0 */ > >>+ 0xbc 0x00 /* lcd_data7.lcd_data7, OUTPUT | MODE0 */ > >>+ 0xc0 0x00 /* lcd_data8.lcd_data8, OUTPUT | MODE0 */ > >>+ 0xc4 0x00 /* lcd_data9.lcd_data9, OUTPUT | MODE0 */ > >>+ 0xc8 0x00 /* lcd_data10.lcd_data10, OUTPUT | MODE0 */ > >>+ 0xcc 0x00 /* lcd_data11.lcd_data11, OUTPUT | MODE0 */ > >>+ 0xd0 0x00 /* lcd_data12.lcd_data12, OUTPUT | MODE0 */ > >>+ 0xd4 0x00 /* lcd_data13.lcd_data13, OUTPUT | MODE0 */ > >>+ 0xd8 0x00 /* lcd_data14.lcd_data14, OUTPUT | MODE0 */ > >>+ 0xdc 0x00 /* lcd_data15.lcd_data15, OUTPUT | MODE0 */ > >>+ 0xe0 0x00 /* lcd_vsync.lcd_vsync, OUTPUT | MODE0 */ > >>+ 0xe4 0x00 /* lcd_hsync.lcd_hsync, OUTPUT | MODE0 */ > >>+ 0xe8 0x00 /* lcd_pclk.lcd_pclk, OUTPUT | MODE0 */ > >>+ 0xec 0x00 /* lcd_ac_bias_en.lcd_ac_bias_en, OUTPUT | MODE0 */ > >>+ >; > >>+ }; > >>+ > >> }; > >> > >> ocp { > >>@@ -311,6 +345,10 @@ > >> }; > >> }; > >> }; > >>+ > >>+ lcdc: lcdc@4830e000 { > >>+ status = "okay"; > >>+ }; > >> }; > >> > >> vbat: fixedregulator@0 { > >>@@ -374,6 +412,40 @@ > >> brightness-levels = <0 51 53 56 62 75 101 152 255>; > >> default-brightness-level = <8>; > >> }; > >>+ > >>+ panel { > >>+ compatible = "ti,tilcdc,panel"; > > Nit: There are a lots of TI here :-) > Could you just name it: ti,lcdc,panel ? > > Thanks, > Benoit > _______________________________________________ dri-devel mailing list dri-devel@xxxxxxxxxxxxxxxxxxxxx http://lists.freedesktop.org/mailman/listinfo/dri-devel
