On 24.06.2024 3:30 AM, Caleb Connolly wrote:
> Initial support for USB, UFS, touchscreen, panel, wifi, and bluetooth.
>
> Co-developed-by: Frieder Hannenheim <frieder.hannenheim@xxxxxxxxx>
> Signed-off-by: Frieder Hannenheim <frieder.hannenheim@xxxxxxxxx>
> Signed-off-by: Caleb Connolly <caleb@xxxxxxxxxxxxxxxx>
> ---
[...]
> +&adsp {
> + status = "okay";
> + firmware-name = "qcom/sm8250/OnePlus/adsp.mbn";
> +};
Status last pls
[...]
> +&gmu {
> + status = "okay";
> +};
already enabled (or should be)
[...]
> +/* LS-I2C1 */
> +&i2c15 {
> + status = "okay";
> +
> + // fcs,fsa4480 @ 42
Just describe it ;)
[...]
> + /* FIXME: There is a bug somewhere in the display stack and it isn't
/*
* FIXME:
> + * possible to get the panel to a working state after toggling reset.
> + * At best it just shows one or more vertical red lines. So for now
> + * let's skip the reset GPIO.
> + */
> + // reset-gpios = <&tlmm 75 GPIO_ACTIVE_LOW>;
/* */
[...]
> +&ufs_mem_hc {
> + status = "okay";
> +
> + vcc-supply = <&vreg_l17a_3p0>;
> + vcc-max-microamp = <800000>;
> + vccq-supply = <&vreg_l6a_1p2>;
> + vccq-max-microamp = <800000>;
> + vccq2-supply = <&vreg_s4a_1p8>;
> + vccq2-max-microamp = <800000>;
allow set mode + allowed modes
Konrad
