Hi Sean,
thanks for your patch.
Tested-by: Yannick Fertre <yannick.fertre@xxxxxxxxxxx>
I think that a helper could be useful in simplifying this part.
This might be reworked when a new helper will be implemented.
Best regards
On 4/22/24 16:05, Sean Nyekjaer wrote:
On Fri, Mar 22, 2024 at 11:47:31AM +0100, Sean Nyekjaer wrote:
When using the DSI interface via DSI2LVDS bridge, it seems a bit harsh
to reguire the requested and the actual px clock to be within
50Hz. A typical LVDS display requires the px clock to be within +-10%.
In case for HDMI .5% tolerance is required.
Fixes: e01356d18273 ("drm/stm: dsi: provide the implementation of mode_valid()")
Signed-off-by: Sean Nyekjaer <sean@xxxxxxxxxx>
---
Any feedback on this?
drivers/gpu/drm/stm/dw_mipi_dsi-stm.c | 7 +++----
1 file changed, 3 insertions(+), 4 deletions(-)
diff --git a/drivers/gpu/drm/stm/dw_mipi_dsi-stm.c b/drivers/gpu/drm/stm/dw_mipi_dsi-stm.c
index d5f8c923d7bc..97936b0ef702 100644
--- a/drivers/gpu/drm/stm/dw_mipi_dsi-stm.c
+++ b/drivers/gpu/drm/stm/dw_mipi_dsi-stm.c
@@ -322,8 +322,6 @@ dw_mipi_dsi_phy_get_timing(void *priv_data, unsigned int lane_mbps,
return 0;
}
-#define CLK_TOLERANCE_HZ 50
-
static enum drm_mode_status
dw_mipi_dsi_stm_mode_valid(void *priv_data,
const struct drm_display_mode *mode,
@@ -375,9 +373,10 @@ dw_mipi_dsi_stm_mode_valid(void *priv_data,
/*
* Filter modes according to the clock value, particularly useful for
* hdmi modes that require precise pixel clocks.
+ * Check that px_clock is within .5% tolerance.
*/
- if (px_clock_hz < target_px_clock_hz - CLK_TOLERANCE_HZ ||
- px_clock_hz > target_px_clock_hz + CLK_TOLERANCE_HZ)
+ if (px_clock_hz < mult_frac(target_px_clock_hz, 995, 1000) ||
+ px_clock_hz > mult_frac(target_px_clock_hz, 1005, 1000))
return MODE_CLOCK_RANGE;
/* sync packets are codes as DSI short packets (4 bytes) */
--
2.44.0
