On Sun, Apr 21, 2024 at 9:36 AM Marek Vasut <marex@xxxxxxx> wrote:
>
> On 2/12/24 12:09 AM, Adam Ford wrote:
> > When using video sync pulses, the HFP, HBP, and HSA are divided between
> > the available lanes if there is more than one lane. For certain
> > timings and lane configurations, the HFP may not be evenly divisible.
> > If the HFP is rounded down, it ends up being too small which can cause
> > some monitors to not sync properly. In these instances, adjust htotal
> > and hsync to round the HFP up, and recalculate the htotal.
> >
> > Tested-by: Frieder Schrempf <frieder.schrempf@xxxxxxxxxx> # Kontron BL i.MX8MM with HDMI monitor
> > Signed-off-by: Adam Ford <aford173@xxxxxxxxx>
> > ---
> > V2: No changes
> >
> > diff --git a/drivers/gpu/drm/bridge/samsung-dsim.c b/drivers/gpu/drm/bridge/samsung-dsim.c
> > index 8476650c477c..52939211fe93 100644
> > --- a/drivers/gpu/drm/bridge/samsung-dsim.c
> > +++ b/drivers/gpu/drm/bridge/samsung-dsim.c
> > @@ -1606,6 +1606,27 @@ static int samsung_dsim_atomic_check(struct drm_bridge *bridge,
> > adjusted_mode->flags |= (DRM_MODE_FLAG_PHSYNC | DRM_MODE_FLAG_PVSYNC);
> > }
> >
> > + /*
> > + * When using video sync pulses, the HFP, HBP, and HSA are divided between
> > + * the available lanes if there is more than one lane. For certain
> > + * timings and lane configurations, the HFP may not be evenly divisible.
> > + * If the HFP is rounded down, it ends up being too small which can cause
> > + * some monitors to not sync properly. In these instances, adjust htotal
> > + * and hsync to round the HFP up, and recalculate the htotal. Through trial
> > + * and error, it appears that the HBP and HSA do not appearto need the same
> > + * correction that HFP does.
> > + */
> > + if (dsi->mode_flags & MIPI_DSI_MODE_VIDEO_SYNC_PULSE && dsi->lanes > 1) {
>
> Does this also apply to mode with sync events (I suspect it does), so
> the condition here should likely be if (!...burst mode) , right ?
Thanks for the review!
I was only able to test it with the DSI->ADV6535 bridge, and I'll
admit I don't know a lot about DSI interface since I don't have a copy
of the spec to read.
Are you proposing this should be:
if (!(dsi->mode_flags & MIPI_DSI_MODE_VIDEO_BURST) && dsi->lanes > 1) {
I just want to make sure I understand what you're requesting.
thanks
adam
