Use .init_load_uA part of the bulk regulator API instead of calling register_set_load() manually. Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxx> --- drivers/gpu/drm/panel/panel-novatek-nt36672a.c | 11 +++-------- 1 file changed, 3 insertions(+), 8 deletions(-) diff --git a/drivers/gpu/drm/panel/panel-novatek-nt36672a.c b/drivers/gpu/drm/panel/panel-novatek-nt36672a.c index 33fb3d715e54..3886372415c2 100644 --- a/drivers/gpu/drm/panel/panel-novatek-nt36672a.c +++ b/drivers/gpu/drm/panel/panel-novatek-nt36672a.c @@ -605,21 +605,16 @@ static int nt36672a_panel_add(struct nt36672a_panel *pinfo) struct device *dev = &pinfo->link->dev; int i, ret; - for (i = 0; i < ARRAY_SIZE(pinfo->supplies); i++) + for (i = 0; i < ARRAY_SIZE(pinfo->supplies); i++) { pinfo->supplies[i].supply = nt36672a_regulator_names[i]; + pinfo->supplies[i].init_load_uA = nt36672a_regulator_enable_loads[i]; + } ret = devm_regulator_bulk_get(dev, ARRAY_SIZE(pinfo->supplies), pinfo->supplies); if (ret < 0) return dev_err_probe(dev, ret, "failed to get regulators\n"); - for (i = 0; i < ARRAY_SIZE(pinfo->supplies); i++) { - ret = regulator_set_load(pinfo->supplies[i].consumer, - nt36672a_regulator_enable_loads[i]); - if (ret) - return dev_err_probe(dev, ret, "failed to set regulator enable loads\n"); - } - pinfo->reset_gpio = devm_gpiod_get(dev, "reset", GPIOD_OUT_LOW); if (IS_ERR(pinfo->reset_gpio)) return dev_err_probe(dev, PTR_ERR(pinfo->reset_gpio), -- 2.39.2