From: "Wachowski, Karol" <karol.wachowski@xxxxxxxxx>
In case of failed power up we end up left in PCI D3hot
state making it impossible to access NPU registers on retry.
Enter D0 state on retry before proceeding with power up sequence.
Fixes: 28083ff18d3f ("accel/ivpu: Fix DevTLB errors on suspend/resume and recovery")
Cc: <stable@xxxxxxxxxxxxxxx> # v6.8+
Signed-off-by: Wachowski, Karol <karol.wachowski@xxxxxxxxx>
Signed-off-by: Jacek Lawrynowicz <jacek.lawrynowicz@xxxxxxxxxxxxxxx>
---
drivers/accel/ivpu/ivpu_pm.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/drivers/accel/ivpu/ivpu_pm.c b/drivers/accel/ivpu/ivpu_pm.c
index 9cbd7af6576b..325b82f8d971 100644
--- a/drivers/accel/ivpu/ivpu_pm.c
+++ b/drivers/accel/ivpu/ivpu_pm.c
@@ -71,10 +71,10 @@ static int ivpu_resume(struct ivpu_device *vdev)
{
int ret;
- pci_set_power_state(to_pci_dev(vdev->drm.dev), PCI_D0);
+retry:
pci_restore_state(to_pci_dev(vdev->drm.dev));
+ pci_set_power_state(to_pci_dev(vdev->drm.dev), PCI_D0);
-retry:
ret = ivpu_hw_power_up(vdev);
if (ret) {
ivpu_err(vdev, "Failed to power up HW: %d\n", ret);
--
2.43.2
