On Sun, Feb 11, 2024 at 5:09 PM Adam Ford <aford173@xxxxxxxxx> wrote:
>
> The P divider should be set based on the min and max values of
> the fin pll which may vary between different platforms.
> These ranges are defined per platform, but hard-coded values
> were used instead which resulted in a smaller range available
> on the i.MX8M[MNP] than what was possible.
>
> As noted by Frieder, there are descripencies between the reference
> manuals of the Mini, Nano and Plus, so I reached out to my NXP
> rep and got the following response regarding the varing notes
> in the documentation.
>
> "Yes it is definitely wrong, the one that is part of the NOTE in
> MIPI_DPHY_M_PLLPMS register table against PMS_P, PMS_M and PMS_S is
> not correct. I will report this to Doc team, the one customer should
> be take into account is the Table 13-40 DPHY PLL Parameters and the
> Note above."
>
> With this patch, the clock rates now match the values used in NXP's
> downstream kernel.
>
Inki,
Any change either or both of these patches could get applied? It's
been several months since the first submission.
Fabio - Do you have an 8MP-evk that you could test to see if there is
any impact? Between these two patches, it fixes the 720p@60 and
likely others too.
adam
> Fixes: 846307185f0f ("drm/bridge: samsung-dsim: update PLL reference clock")
> Signed-off-by: Adam Ford <aford173@xxxxxxxxx>
> Reviewed-by: Frieder Schrempf <frieder.schrempf@xxxxxxxxxx>
> Tested-by: Frieder Schrempf <frieder.schrempf@xxxxxxxxxx>
> ---
> V2: Only update the commit message to reflect why these values
> were chosen. No code change present
>
> diff --git a/drivers/gpu/drm/bridge/samsung-dsim.c b/drivers/gpu/drm/bridge/samsung-dsim.c
> index 95fedc68b0ae..8476650c477c 100644
> --- a/drivers/gpu/drm/bridge/samsung-dsim.c
> +++ b/drivers/gpu/drm/bridge/samsung-dsim.c
> @@ -574,8 +574,8 @@ static unsigned long samsung_dsim_pll_find_pms(struct samsung_dsim *dsi,
> u16 _m, best_m;
> u8 _s, best_s;
>
> - p_min = DIV_ROUND_UP(fin, (12 * MHZ));
> - p_max = fin / (6 * MHZ);
> + p_min = DIV_ROUND_UP(fin, (driver_data->pll_fin_max * MHZ));
> + p_max = fin / (driver_data->pll_fin_min * MHZ);
>
> for (_p = p_min; _p <= p_max; ++_p) {
> for (_s = 0; _s <= 5; ++_s) {
> --
> 2.43.0
>
