ZynqMP DPSUB supports 2 input modes: DMA based and live video. In the first mode, the driver implements CRTC and DP encoder DRM bridge to model the complete display pipeline. In this case, DRM bridge is being directly instantiated within the driver, not using any bridge discovery mechanisms. In the live video input mode video signal is generated by FPGA fabric and passed into DPSUB over the connected bus. In this mode driver exposes the DP encoder as a DRM bridge, expecting external CRTC to discover it via drm_of_find_panel_or_bridge() or a similar call. This discovery relies on drm_bridge.of_node being properly set. Assign device OF node to the bridge prior to registering it. This will make said bridge discoverable by an external CRTC driver. Reviewed-by: Tomi Valkeinen <tomi.valkeinen@xxxxxxxxxxxxxxxx> Reviewed-by: Laurent Pinchart <laurent.pinchart@xxxxxxxxxxxxxxxx> Signed-off-by: Anatoliy Klymenko <anatoliy.klymenko@xxxxxxx> --- drivers/gpu/drm/xlnx/zynqmp_dp.c | 1 + 1 file changed, 1 insertion(+) diff --git a/drivers/gpu/drm/xlnx/zynqmp_dp.c b/drivers/gpu/drm/xlnx/zynqmp_dp.c index a0606fab0e22..d60b7431603f 100644 --- a/drivers/gpu/drm/xlnx/zynqmp_dp.c +++ b/drivers/gpu/drm/xlnx/zynqmp_dp.c @@ -1721,6 +1721,7 @@ int zynqmp_dp_probe(struct zynqmp_dpsub *dpsub) bridge->ops = DRM_BRIDGE_OP_DETECT | DRM_BRIDGE_OP_EDID | DRM_BRIDGE_OP_HPD; bridge->type = DRM_MODE_CONNECTOR_DisplayPort; + bridge->of_node = dp->dev->of_node; dpsub->bridge = bridge; /* -- 2.25.1
