On Fri, 15 Sep 2023 16:05:15 +0200, Flavio Suligoi wrote: > The Monolithic Power (MPS) MP3309C is a WLED step-up converter, featuring a > programmable switching frequency to optimize efficiency. > The brightness can be controlled either by I2C commands (called "analog" > mode) or by a PWM input signal (PWM mode). > This driver supports both modes. > > For device driver details, please refer to: > - drivers/video/backlight/mp3309c_bl.c > > The datasheet is available at: > - https://www.monolithicpower.com/en/mp3309c.html > > Signed-off-by: Flavio Suligoi <f.suligoi@xxxxxxx> > --- > > v2: > - remove useless properties (dimming-mode, pinctrl-names, pinctrl-0, > switch-on-delay-ms, switch-off-delay-ms, reset-gpios, reset-on-delay-ms, > reset-on-length-ms) > - add common.yaml# > - remove already included properties (default-brightness, max-brightness) > - substitute three boolean properties, used for the overvoltage-protection > values, with a single enum property > - remove some conditional definitions > - remove the 2nd example > v1: > - first version > > .../bindings/leds/backlight/mps,mp3309c.yaml | 73 +++++++++++++++++++ > 1 file changed, 73 insertions(+) > create mode 100644 Documentation/devicetree/bindings/leds/backlight/mps,mp3309c.yaml > My bot found errors running 'make DT_CHECKER_FLAGS=-m dt_binding_check' on your patch (DT_CHECKER_FLAGS is new in v5.13): yamllint warnings/errors: dtschema/dtc warnings/errors: Documentation/devicetree/bindings/leds/backlight/mps,mp3309c.example.dtb: /example-0/i2c/backlight@17: failed to match any schema with compatible: ['mps,mp3309c-backlight'] doc reference errors (make refcheckdocs): See https://patchwork.ozlabs.org/project/devicetree-bindings/patch/20230915140516.1294925-1-f.suligoi@xxxxxxx The base for the series is generally the latest rc1. A different dependency should be noted in *this* patch. If you already ran 'make dt_binding_check' and didn't see the above error(s), then make sure 'yamllint' is installed and dt-schema is up to date: pip3 install dtschema --upgrade Please check and re-submit after running the above command yourself. Note that DT_SCHEMA_FILES can be set to your schema file to speed up checking your schema. However, it must be unset to test all examples with your schema.
