On 29/06/2023 22:29, Abhinav Kumar wrote:
Instead of using a feature bit to decide whether to enable data
compress or not for DSC use-cases, use dpu core's major version instead.
This will avoid defining feature bits for every bit level details of
registers.
Also, rename the intf's enable_compression() op to program_datapath()
and allow it to accept a struct intf_dpu_datapath_cfg to program
all the bits at once. This can be re-used by widebus later on as
well as it touches the same register.
Two separate commits please, because...
Signed-off-by: Abhinav Kumar <quic_abhinavk@xxxxxxxxxxx>
---
.../gpu/drm/msm/disp/dpu1/dpu_encoder_phys_cmd.c | 9 +++++++--
drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.c | 9 +++++----
drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.h | 16 ++++++++++++++--
3 files changed, 26 insertions(+), 8 deletions(-)
diff --git a/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_cmd.c b/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_cmd.c
index b856c6286c85..f4e15b4c4cc9 100644
--- a/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_cmd.c
+++ b/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_cmd.c
@@ -50,6 +50,7 @@ static void _dpu_encoder_phys_cmd_update_intf_cfg(
to_dpu_encoder_phys_cmd(phys_enc);
struct dpu_hw_ctl *ctl;
struct dpu_hw_intf_cfg intf_cfg = { 0 };
+ struct dpu_kms *dpu_kms = phys_enc->dpu_kms;
ctl = phys_enc->hw_ctl;
if (!ctl->ops.setup_intf_cfg)
@@ -68,8 +69,12 @@ static void _dpu_encoder_phys_cmd_update_intf_cfg(
phys_enc->hw_intf,
phys_enc->hw_pp->idx);
- if (intf_cfg.dsc != 0 && phys_enc->hw_intf->ops.enable_compression)
- phys_enc->hw_intf->ops.enable_compression(phys_enc->hw_intf);
+ if (intf_cfg.dsc != 0 && dpu_kms->catalog->core_major_version >= 0x7) {
... because this becomes incorrect. The datapath should be programmed in
all the cases, if there is a corresponding callback. intf_cfg.dsc should
be used as a condition to set datapath_cfg.
+ struct intf_dpu_datapath_cfg datapath_cfg = { 0 };
No need for `0' in the init, empty braces would be enough.
+
+ datapath_cfg.data_compress = true;
+ phys_enc->hw_intf->ops.program_datapath(phys_enc->hw_intf, &datapath_cfg);
+ }
}
static void dpu_encoder_phys_cmd_pp_tx_done_irq(void *arg, int irq_idx)
diff --git a/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.c b/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.c
index 5b0f6627e29b..85333df08fbc 100644
--- a/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.c
+++ b/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.c
@@ -513,11 +513,13 @@ static void dpu_hw_intf_disable_autorefresh(struct dpu_hw_intf *intf,
}
-static void dpu_hw_intf_enable_compression(struct dpu_hw_intf *ctx)
+static void dpu_hw_intf_program_datapath(struct dpu_hw_intf *ctx,
+ struct intf_dpu_datapath_cfg *datapath_cfg)
{
u32 intf_cfg2 = DPU_REG_READ(&ctx->hw, INTF_CONFIG2);
- intf_cfg2 |= INTF_CFG2_DCE_DATA_COMPRESS;
+ if (datapath_cfg->data_compress)
+ intf_cfg2 |= INTF_CFG2_DCE_DATA_COMPRESS;
DPU_REG_WRITE(&ctx->hw, INTF_CONFIG2, intf_cfg2);
}
@@ -543,8 +545,7 @@ static void _setup_intf_ops(struct dpu_hw_intf_ops *ops,
ops->disable_autorefresh = dpu_hw_intf_disable_autorefresh;
}
- if (cap & BIT(DPU_INTF_DATA_COMPRESS))
- ops->enable_compression = dpu_hw_intf_enable_compression;
+ ops->program_datapath = dpu_hw_intf_program_datapath;
The `core_major_version >= 7' should either be here or in the callback
itself.
}
struct dpu_hw_intf *dpu_hw_intf_init(const struct dpu_intf_cfg *cfg,
diff --git a/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.h b/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.h
index 99e21c4137f9..f736dca38463 100644
--- a/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.h
+++ b/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.h
@@ -48,6 +48,11 @@ struct intf_status {
u32 line_count; /* current line count including blanking */
};
+struct intf_dpu_datapath_cfg {
+ u8 data_compress; /* enable data compress between dpu and dsi */
+ /* can be expanded for other programmable bits */
+};
I'd say, dpu_datapath is too generic. What about intf_cmd_mode_cfg?
+
/**
* struct dpu_hw_intf_ops : Interface to the interface Hw driver functions
* Assumption is these functions will be called after clocks are enabled
@@ -70,7 +75,7 @@ struct intf_status {
* @get_autorefresh: Retrieve autorefresh config from hardware
* Return: 0 on success, -ETIMEDOUT on timeout
* @vsync_sel: Select vsync signal for tear-effect configuration
- * @enable_compression: Enable data compression
+ * @program_datapath: Program the DPU to interface datapath for relevant chipsets
*/
struct dpu_hw_intf_ops {
void (*setup_timing_gen)(struct dpu_hw_intf *intf,
@@ -108,7 +113,14 @@ struct dpu_hw_intf_ops {
*/
void (*disable_autorefresh)(struct dpu_hw_intf *intf, uint32_t encoder_id, u16 vdisplay);
- void (*enable_compression)(struct dpu_hw_intf *intf);
+ /**
+ * Program the DPU to intf datapath by specifying
+ * which of the settings need to be programmed for
+ * use-cases which need DPU-intf handshake such as
+ * widebus, compression etc.
This is not a valid kerneldoc.
+ */
+ void (*program_datapath)(struct dpu_hw_intf *intf,
+ struct intf_dpu_datapath_cfg *datapath_cfg);
};
struct dpu_hw_intf {
--
With best wishes
Dmitry
