Hi Sandor,
On Thu, Jun 15, 2023 at 09:38:13AM +0800, Sandor Yu wrote:
> Add a new DRM DisplayPort bridge driver for Candence MHDP8501
> used in i.MX8MQ SOC. MHDP8501 could support HDMI or DisplayPort
> standards according embedded Firmware running in the uCPU.
>
> For iMX8MQ SOC, the DisplayPort FW was loaded and activated by SOC
> ROM code. Bootload binary included HDMI FW was required for the driver.
The bridge driver supports creating a connector, but is this really
necessary?
This part:
> +static const struct drm_connector_funcs cdns_dp_connector_funcs = {
> + .fill_modes = drm_helper_probe_single_connector_modes,
> + .destroy = drm_connector_cleanup,
> + .reset = drm_atomic_helper_connector_reset,
> + .atomic_duplicate_state = drm_atomic_helper_connector_duplicate_state,
> + .atomic_destroy_state = drm_atomic_helper_connector_destroy_state,
> +};
> +
> +static const struct drm_connector_helper_funcs cdns_dp_connector_helper_funcs = {
> + .get_modes = cdns_dp_connector_get_modes,
> +};
> +
> +static int cdns_dp_bridge_attach(struct drm_bridge *bridge,
> + enum drm_bridge_attach_flags flags)
> +{
> + struct cdns_mhdp_device *mhdp = bridge->driver_private;
> + struct drm_encoder *encoder = bridge->encoder;
> + struct drm_connector *connector = &mhdp->connector;
> + int ret;
> +
> + if (!(flags & DRM_BRIDGE_ATTACH_NO_CONNECTOR)) {
> + connector->interlace_allowed = 0;
> +
> + connector->polled = DRM_CONNECTOR_POLL_HPD;
> +
> + drm_connector_helper_add(connector, &cdns_dp_connector_helper_funcs);
> +
> + drm_connector_init(bridge->dev, connector, &cdns_dp_connector_funcs,
> + DRM_MODE_CONNECTOR_DisplayPort);
> +
> + drm_connector_attach_encoder(connector, encoder);
> + }
Unless you have a display driver that do not create their own connector
then drop the above and error out if DRM_BRIDGE_ATTACH_NO_CONNECTOR is
not set.
It is encouraged that display drivers create their own connector.
This was the only detail I looked for in the driver, I hope some else
volunteer to review it.
Sam
