Re: [PATCH 7/7] drm/panel: sitronix-st7789v: Check display ID

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hi,

On Sat, Jun 10, 2023 at 10:45:25PM +0200, Sam Ravnborg wrote:
> Hi Miquel,
> 
> On Fri, Jun 09, 2023 at 04:59:51PM +0200, Miquel Raynal wrote:
> > A very basic debugging rule when a device is connected for the first
> > time is to access a read-only register which contains known data in
> > order to ensure the communication protocol is properly working. This
> > driver lacked any read helper which is often a critical peace for
> > fastening bring-ups.
> > 
> > Add a read helper and use it to verify the communication with the panel
> > is working as soon as possible in order to fail early if this is not the
> > case.
> 
> The read helper seems like a log of general boiler plate code.
> I briefly looked into the use of regmap for the spi communication,
> but it did not look like it supported the bit9 stuff.
> 
> I did not stare enough to add a reviewd by, but the approach is fine
> and it is good to detech issues early.

The st7789v datasheet describes a setup where SPI is connected
unidirectional (i.e. without MISO). In that case the ID check
will fail.

-- Sebastian

> 
> Acked-by: Sam Ravnborg <sam@xxxxxxxxxxxx>
> > 
> > Signed-off-by: Miquel Raynal <miquel.raynal@xxxxxxxxxxx>
> > ---
> >  .../gpu/drm/panel/panel-sitronix-st7789v.c    | 78 +++++++++++++++++++
> >  1 file changed, 78 insertions(+)
> > 
> > diff --git a/drivers/gpu/drm/panel/panel-sitronix-st7789v.c b/drivers/gpu/drm/panel/panel-sitronix-st7789v.c
> > index 7de192a3a8aa..fb21d52a7a63 100644
> > --- a/drivers/gpu/drm/panel/panel-sitronix-st7789v.c
> > +++ b/drivers/gpu/drm/panel/panel-sitronix-st7789v.c
> > @@ -113,6 +113,9 @@
> >  			return val;		\
> >  	} while (0)
> >  
> > +#define ST7789V_IDS { 0x85, 0x85, 0x52 }
> > +#define ST7789V_IDS_SIZE 3
> > +
> >  struct st7789v_panel_info {
> >  	const struct drm_display_mode *display_mode;
> >  	u16 width_mm;
> > @@ -165,6 +168,77 @@ static int st7789v_write_data(struct st7789v *ctx, u8 cmd)
> >  	return st7789v_spi_write(ctx, ST7789V_DATA, cmd);
> >  }
> >  
> > +static int st7789v_read_data(struct st7789v *ctx, u8 cmd, u8 *buf,
> > +			     unsigned int len)
> > +{
> > +	struct spi_transfer xfer[2] = { };
> > +	struct spi_message msg;
> > +	u16 txbuf = ((ST7789V_COMMAND & 1) << 8) | cmd;
> > +	u16 rxbuf[4] = {};
> > +	u8 bit9 = 0;
> > +	int ret, i;
> > +
> > +	switch (len) {
> > +	case 1:
> > +	case 3:
> > +	case 4:
> > +		break;
> > +	default:
> > +		return -EOPNOTSUPP;
> > +	}
> > +
> > +	spi_message_init(&msg);
> > +
> > +	xfer[0].tx_buf = &txbuf;
> > +	xfer[0].len = sizeof(txbuf);
> > +	spi_message_add_tail(&xfer[0], &msg);
> > +
> > +	xfer[1].rx_buf = rxbuf;
> > +	xfer[1].len = len * 2;
> > +	spi_message_add_tail(&xfer[1], &msg);
> > +
> > +	ret = spi_sync(ctx->spi, &msg);
> > +	if (ret)
> > +		return ret;
> > +
> > +	for (i = 0; i < len; i++) {
> > +		buf[i] = rxbuf[i] >> i | (bit9 << (9 - i));
> > +		if (i)
> > +			bit9 = rxbuf[i] & GENMASK(i - 1, 0);
> > +	}
> > +
> > +	return 0;
> > +}
> > +
> > +static int st7789v_check_id(struct drm_panel *panel)
> > +{
> > +	const u8 st7789v_ids[ST7789V_IDS_SIZE] = ST7789V_IDS;
> > +	struct st7789v *ctx = panel_to_st7789v(panel);
> > +	bool invalid_ids = false;
> > +	int ret, i;
> > +	u8 ids[3];
> > +
> > +	ret = st7789v_read_data(ctx, MIPI_DCS_GET_DISPLAY_ID, ids, ST7789V_IDS_SIZE);
> > +	if (ret) {
> > +		dev_err(panel->dev, "Failed to read IDs\n");
> > +		return ret;
> > +	}
> > +
> > +	for (i = 0; i < ST7789V_IDS_SIZE; i++) {
> > +		if (ids[i] != st7789v_ids[i]) {
> > +			invalid_ids = true;
> > +			break;
> > +		}
> > +	}
> > +
> > +	if (invalid_ids) {
> > +		dev_err(panel->dev, "Unrecognized panel IDs");
> > +		return -EIO;
> > +	}
> > +
> > +	return 0;
> > +}
> > +
> >  static const struct drm_display_mode default_mode = {
> >  	.clock = 7000,
> >  	.hdisplay = 240,
> > @@ -237,6 +311,10 @@ static int st7789v_prepare(struct drm_panel *panel)
> >  	gpiod_set_value(ctx->reset, 0);
> >  	msleep(120);
> >  
> > +	ret = st7789v_check_id(panel);
> > +	if (ret)
> > +		return ret;
> > +
> >  	ST7789V_TEST(ret, st7789v_write_command(ctx, MIPI_DCS_EXIT_SLEEP_MODE));
> >  
> >  	/* We need to wait 120ms after a sleep out command */
> > -- 
> > 2.34.1

Attachment: signature.asc
Description: PGP signature


[Index of Archives]     [Linux DRI Users]     [Linux Intel Graphics]     [Linux USB Devel]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Linux USB Devel]     [Video for Linux]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]
  Powered by Linux