On 2023-06-09 15:57:16, Jessica Zhang wrote: > Add a DPU INTF op to set the DCE_DATA_COMPRESS bit to enable the > DCE/DSC 1.2 datapath > > Note: For now, this op is called for command mode encoders only. Changes to > set DATA_COMPRESS for video mode encoders will be posted along with DSC > v1.2 support for DP. > > Signed-off-by: Jessica Zhang <quic_jesszhan@xxxxxxxxxxx> > --- > drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_cmd.c | 3 +++ > drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.c | 13 +++++++++++++ > drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.h | 3 +++ > 3 files changed, 19 insertions(+) > > diff --git a/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_cmd.c b/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_cmd.c > index 63ba0082b6ee..b856c6286c85 100644 > --- a/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_cmd.c > +++ b/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_cmd.c > @@ -67,6 +67,9 @@ static void _dpu_encoder_phys_cmd_update_intf_cfg( > phys_enc->hw_intf->ops.bind_pingpong_blk( > phys_enc->hw_intf, > phys_enc->hw_pp->idx); > + > + if (intf_cfg.dsc != 0 && phys_enc->hw_intf->ops.enable_compression) > + phys_enc->hw_intf->ops.enable_compression(phys_enc->hw_intf); It was probably not necessary to drop this after adding dsc!=0: Reviewed-by: Marijn Suijten <marijn.suijten@xxxxxxxxxxxxxx> > } > > static void dpu_encoder_phys_cmd_pp_tx_done_irq(void *arg, int irq_idx) > diff --git a/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.c b/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.c > index 530f82e34c1e..5b0f6627e29b 100644 > --- a/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.c > +++ b/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.c > @@ -91,6 +91,7 @@ > > #define INTF_CFG2_DATABUS_WIDEN BIT(0) > #define INTF_CFG2_DATA_HCTL_EN BIT(4) > +#define INTF_CFG2_DCE_DATA_COMPRESS BIT(12) > > > static void dpu_hw_intf_setup_timing_engine(struct dpu_hw_intf *ctx, > @@ -512,6 +513,15 @@ static void dpu_hw_intf_disable_autorefresh(struct dpu_hw_intf *intf, > > } > > +static void dpu_hw_intf_enable_compression(struct dpu_hw_intf *ctx) > +{ > + u32 intf_cfg2 = DPU_REG_READ(&ctx->hw, INTF_CONFIG2); > + > + intf_cfg2 |= INTF_CFG2_DCE_DATA_COMPRESS; > + > + DPU_REG_WRITE(&ctx->hw, INTF_CONFIG2, intf_cfg2); > +} > + > static void _setup_intf_ops(struct dpu_hw_intf_ops *ops, > unsigned long cap) > { > @@ -532,6 +542,9 @@ static void _setup_intf_ops(struct dpu_hw_intf_ops *ops, > ops->vsync_sel = dpu_hw_intf_vsync_sel; > ops->disable_autorefresh = dpu_hw_intf_disable_autorefresh; > } > + > + if (cap & BIT(DPU_INTF_DATA_COMPRESS)) > + ops->enable_compression = dpu_hw_intf_enable_compression; > } > > struct dpu_hw_intf *dpu_hw_intf_init(const struct dpu_intf_cfg *cfg, > diff --git a/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.h b/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.h > index 33895eca1211..99e21c4137f9 100644 > --- a/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.h > +++ b/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.h > @@ -70,6 +70,7 @@ struct intf_status { > * @get_autorefresh: Retrieve autorefresh config from hardware > * Return: 0 on success, -ETIMEDOUT on timeout > * @vsync_sel: Select vsync signal for tear-effect configuration > + * @enable_compression: Enable data compression > */ > struct dpu_hw_intf_ops { > void (*setup_timing_gen)(struct dpu_hw_intf *intf, > @@ -106,6 +107,8 @@ struct dpu_hw_intf_ops { > * Disable autorefresh if enabled > */ > void (*disable_autorefresh)(struct dpu_hw_intf *intf, uint32_t encoder_id, u16 vdisplay); > + > + void (*enable_compression)(struct dpu_hw_intf *intf); > }; > > struct dpu_hw_intf { > > -- > 2.40.1 >