Adam, Neil, I meant to get to this earlier today, but broken CI got in the way... On Thu, May 25, 2023 at 10:05:59PM -0500, Adam Ford wrote: > In the event a device is connected to the samsung-dsim > controller that doesn't support the burst-clock, the > driver is able to get the requested pixel clock from the > attached device or bridge. In these instances, the > samsung,burst-clock-frequency isn't needed, so remove > it from the required list. > > The pll-clock frequency can be set by the device tree entry > for samsung,pll-clock-frequency, but in some cases, the > pll-clock may have the same clock rate as sclk_mipi clock. > If they are equal, this flag is not needed since the driver > will use the sclk_mipi rate as a fallback. > > Signed-off-by: Adam Ford <aford173@xxxxxxxxx> > --- > .../bindings/display/bridge/samsung,mipi-dsim.yaml | 9 +++++---- > 1 file changed, 5 insertions(+), 4 deletions(-) > > diff --git a/Documentation/devicetree/bindings/display/bridge/samsung,mipi-dsim.yaml b/Documentation/devicetree/bindings/display/bridge/samsung,mipi-dsim.yaml > index 9f61ebdfefa8..360fea81f4b6 100644 > --- a/Documentation/devicetree/bindings/display/bridge/samsung,mipi-dsim.yaml > +++ b/Documentation/devicetree/bindings/display/bridge/samsung,mipi-dsim.yaml > @@ -70,7 +70,9 @@ properties: > samsung,burst-clock-frequency: > $ref: /schemas/types.yaml#/definitions/uint32 > description: > - DSIM high speed burst mode frequency. > + DSIM high speed burst mode frequency when connected to devices > + that support burst mode. If absent, the driver will use the pixel > + clock from the attached device or bridge. I'd rather this description did not say anything about drivers. How about: If absent, the pixel clock from the attached device or bridge will be used instead. Or perhaps "must be used"? Ditto below. Description aside, the removal seems to be backwards compatible - but can every device that this binding supports work using an "attached device or bridge", or are these properties going to be required for certain compatibles? Thanks, Conor. > > samsung,esc-clock-frequency: > $ref: /schemas/types.yaml#/definitions/uint32 > @@ -80,7 +82,8 @@ properties: > samsung,pll-clock-frequency: > $ref: /schemas/types.yaml#/definitions/uint32 > description: > - DSIM oscillator clock frequency. > + DSIM oscillator clock frequency. If absent, the driver will > + use the clock frequency of sclk_mipi. > > phys: > maxItems: 1 > @@ -134,9 +137,7 @@ required: > - compatible > - interrupts > - reg > - - samsung,burst-clock-frequency > - samsung,esc-clock-frequency > - - samsung,pll-clock-frequency > > allOf: > - $ref: ../dsi-controller.yaml# > -- > 2.39.2 >
Attachment:
signature.asc
Description: PGP signature