On 22/05/2023 12:10, Neil Armstrong wrote:
On 18/05/2023 02:19, Dmitry Baryshkov wrote:
On 16/05/2023 23:20, Jessica Zhang wrote:
Add support for the 1080x2340 Visionox R66451 AMOLED DSI panel that
comes with the Qualcomm HDK8350 display expansion pack.
The panel enables display compression (DSC v1.2) by default.
Signed-off-by: Jessica Zhang <quic_jesszhan@xxxxxxxxxxx>
---
drivers/gpu/drm/panel/Kconfig | 8 +
drivers/gpu/drm/panel/Makefile | 1 +
drivers/gpu/drm/panel/panel-visionox-r66451.c | 395
++++++++++++++++++++++++++
3 files changed, 404 insertions(+)
[skipped]
+
+ ret = mipi_dsi_dcs_exit_sleep_mode(dsi);
+ if (ret < 0) {
+ dev_err(dev, "Failed to exit sleep mode: %d\n", ret);
+ return ret;
+ }
+ msleep(120);
+
+ ret = mipi_dsi_dcs_set_display_on(dsi);
Should the mipi_dsi_dcs_set_display_on() (and maybe exit sleep mode)
be a a part of _enable()? Correspondingly _off should IMO be a part of
_disable callback().
Nop, mipi_dsi_dcs_set_display_on() should be part of prepare, to be
called *before* the video stream starts, enable is called after in the
atomic modeset chain,
To summarize our discussion: some controllers do not support sending
commands in non-LPM mode. Thus the panel driver should send all commands
before the DSI host switches from LPM to VIDEO mode.
Is this corret?
+ if (ret < 0) {
+ dev_err(dev, "Failed on set display on: %d\n", ret);
+ return ret;
+ }
+ msleep(20);
Do we need to add here the following line?
dsi->mode_flags &= ~MIPI_DSI_MODE_LPM;
No, it will be changed by the DSI core.
Hmm, where?
+
+ return 0;
+}
[skipped]
+static int visionox_r66451_bl_update_status(struct backlight_device
*bl)
+{
+ struct mipi_dsi_device *dsi = bl_get_data(bl);
+ u16 brightness = backlight_get_brightness(bl);
+
+ return mipi_dsi_dcs_set_display_brightness(dsi,
cpu_to_le16(brightness));
mipi_dsi_dcs_set_display_brightness() already converts the brightness,
so you don't need cpu_to_le16 here.
The _large variant must be used instead.
But cpu_to_le16 is NOP, isn't it?
--
With best wishes
Dmitry