From: Francesco Dolcini <francesco.dolcini@xxxxxxxxxxx> Always enable HS video mode setting the TXMD bit, without this change no video output is present with DSI sinks that are setting MIPI_DSI_MODE_LPM flag (tested with LT8912B DSI-HDMI bridge). Previously the driver was enabling HS mode only when the DSI sink was not explicitly setting the MIPI_DSI_MODE_LPM, however this is not correct. The MIPI_DSI_MODE_LPM is supposed to indicate that the sink is willing to receive data in low power mode, however clearing the TC358768_DSI_CONTROL_TXMD bit will make the TC358768 send video in LP mode that is not the intended behavior. Fixes: ff1ca6397b1d ("drm/bridge: Add tc358768 driver") Signed-off-by: Francesco Dolcini <francesco.dolcini@xxxxxxxxxxx> --- drivers/gpu/drm/bridge/tc358768.c | 3 +-- 1 file changed, 1 insertion(+), 2 deletions(-) diff --git a/drivers/gpu/drm/bridge/tc358768.c b/drivers/gpu/drm/bridge/tc358768.c index 7c0cbe84611b..8f349bf4fc32 100644 --- a/drivers/gpu/drm/bridge/tc358768.c +++ b/drivers/gpu/drm/bridge/tc358768.c @@ -866,8 +866,7 @@ static void tc358768_bridge_pre_enable(struct drm_bridge *bridge) val = TC358768_DSI_CONFW_MODE_SET | TC358768_DSI_CONFW_ADDR_DSI_CONTROL; val |= (dsi_dev->lanes - 1) << 1; - if (!(dsi_dev->mode_flags & MIPI_DSI_MODE_LPM)) - val |= TC358768_DSI_CONTROL_TXMD; + val |= TC358768_DSI_CONTROL_TXMD; if (!(mode_flags & MIPI_DSI_CLOCK_NON_CONTINUOUS)) val |= TC358768_DSI_CONTROL_HSCKMD; -- 2.25.1