On Thu, Apr 13, 2023 at 03:56:21PM +0200, Andi Shyti wrote: > Hi Tvrtko, > > (I forgot to CC Daniele) > > On Thu, Apr 13, 2023 at 11:41:28AM +0100, Tvrtko Ursulin wrote: > > > > On 13/04/2023 10:20, Andi Shyti wrote: > > > From: Paulo Zanoni <paulo.r.zanoni@xxxxxxxxx> > > > > > > In multitile systems IRQ need to be reset and enabled per GT. > > > > > > Although in MTL the GUnit misc interrupts register set are > > > available only in GT-0, we need to loop through all the GT's > > > in order to initialize the media engine which lies on a different > > > GT. > > > > > > Signed-off-by: Paulo Zanoni <paulo.r.zanoni@xxxxxxxxx> > > > Cc: Tvrtko Ursulin <tvrtko.ursulin@xxxxxxxxx> > > > Signed-off-by: Andi Shyti <andi.shyti@xxxxxxxxxxxxxxx> > > > --- > > > Hi, > > > > > > proposing again this patch, apparently GuC needs this patch to > > > initialize the media GT. > > > > What is the resolution for Matt's concern that this is wrong for MTL? > > There are two explanations, one easy and one less easy. > > The easy one: without this patch i915 doesn't boot on MTL!(*) > > The second explanation is that in MTL the media engine has it's > own set of misc irq's registers and those are on a different GT > (Daniele pointed this out). Assuming you're talking about MTL_GUC_MGUC_INTR_MASK, that's not true; it's just a single sgunit register (0x1900e8) that has different bitfields for the primary GuC and the media GuC. So I still think we should avoid looping over GTs; it's actually much simpler to handle things in a single pass since we can just determine the single register value once (all fields) and write it directly, instead of doing two separate RMW updates to the same register to try to avoid clobbering the other GuC's settings. For pre-MTL platforms, it's the same register, except that the bitfield now devoted to the media GuC was previously used for something else (scatter/gather). Matt > > I sent this patch not to bypass any review, but to restart the > discussion as this patch was just dropped. > > Thanks, > Andi > > > (*) > [drm] *ERROR* GT1: GUC: CT: No response for request 0x550a (fence 7) > [drm] *ERROR* GT1: GUC: CT: Sending action 0x550a failed (-ETIMEDOUT) status=0X0 > [drm] *ERROR* GT1: GUC: Failed to enable usage stats: -ETIMEDOUT > [drm] *ERROR* GT1: GuC initialization failed -ETIMEDOUT > [drm] *ERROR* GT1: Enabling uc failed (-5) > [drm] *ERROR* GT1: Failed to initialize GPU, declaring it wedged! -- Matt Roper Graphics Software Engineer Linux GPU Platform Enablement Intel Corporation
