Re: [PATCH v2 2/2] drm: rcar-du: Write correct values in DORCR reserved fields

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 23/02/2023 01:42, Laurent Pinchart wrote:
The DORCR register controls the routing of clocks and data between DU
channels within a group. For groups that contain a single channel,
there's no routing option to control, and some fields of the register
are then reserved. On Gen2 those reserved fields are documented as
required to be set to 0, while on Gen3 and newer the PG1T, DK1S and PG1D
reserved fields must be set to 1.

The DU driver initializes the DORCR register in rcar_du_group_setup(),
where it ignores the PG1T, DK1S and PG1D, and then configures those
fields to the correct value in rcar_du_group_set_routing(). This hasn't
been shown to cause any issue, but prevents certifying that the driver
complies with the documentation in safety-critical use cases.

As there is no reasonable change that the documentation will be updated
to clarify that those reserved fields can be written to 0 temporarily
before starting the hardware, make sure that the registers are always
set to valid values.

Signed-off-by: Laurent Pinchart <laurent.pinchart+renesas@xxxxxxxxxxxxxxxx>
---
  drivers/gpu/drm/rcar-du/rcar_du_group.c | 10 +++++++++-
  1 file changed, 9 insertions(+), 1 deletion(-)

Reviewed-by: Tomi Valkeinen <tomi.valkeinen@xxxxxxxxxxxxxxxx>

 Tomi




[Index of Archives]     [Linux DRI Users]     [Linux Intel Graphics]     [Linux USB Devel]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Linux USB Devel]     [Video for Linux]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]
  Powered by Linux