From: Xinlei Lee <xinlei.lee@xxxxxxxxxxxx>
According to Figure 16 Turnaround Procedure on page 36 in [1], you
can see the status of LP-00 -> LP10 -> LP11. This state can correspond
to the state of DSI from LP00 -> LP11 in mtk_dsi_lane_ready function
in mtk_dsi.c.
LP-00 -> LP10 -> LP11 takes about 2*TLPX time (refer to [1] page 51
to see that TLPX is 50ns).
The delay at the end of the mtk_dsi_lane_ready function should be
greater than the 2*TLPX specified by the DSI spec, and less than
the time specified by the DSI_RX (generally 6ms to 40ms), to avoid
problems caused by the RX specification.
[1]:mipi_D-PHY_specification_v1-1
Fixes: 39e8d062b03c ("drm/mediatek: Keep dsi as LP00 before dcs cmds transfer")
Signed-off-by: Xinlei Lee <xinlei.lee@xxxxxxxxxxxx>
---
drivers/gpu/drm/mediatek/mtk_dsi.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/drivers/gpu/drm/mediatek/mtk_dsi.c b/drivers/gpu/drm/mediatek/mtk_dsi.c
index 3b7d13028fb6..9e1363c9fcdb 100644
--- a/drivers/gpu/drm/mediatek/mtk_dsi.c
+++ b/drivers/gpu/drm/mediatek/mtk_dsi.c
@@ -721,7 +721,7 @@ static void mtk_dsi_lane_ready(struct mtk_dsi *dsi)
mtk_dsi_clk_ulp_mode_leave(dsi);
mtk_dsi_lane0_ulp_mode_leave(dsi);
mtk_dsi_clk_hs_mode(dsi, 0);
- msleep(20);
+ usleep_range(1000, 3000);
/* The reaction time after pulling up the mipi signal for dsi_rx */
}
}
--
2.18.0
