On 29.11.2022 21:46, Adam Skladowski wrote:
> Add nodes required for TSENS block using the common qcom,tsens-v2 binding.
>
> Signed-off-by: Adam Skladowski <a39.skl@xxxxxxxxx>
> ---
Reviewed-by: Konrad Dybcio <konrad.dybcio@xxxxxxxxxx>
Konrad
> arch/arm64/boot/dts/qcom/sm6115.dtsi | 11 +++++++++++
> 1 file changed, 11 insertions(+)
>
> diff --git a/arch/arm64/boot/dts/qcom/sm6115.dtsi b/arch/arm64/boot/dts/qcom/sm6115.dtsi
> index 2003a2519a54..decbf7ca8a03 100644
> --- a/arch/arm64/boot/dts/qcom/sm6115.dtsi
> +++ b/arch/arm64/boot/dts/qcom/sm6115.dtsi
> @@ -515,6 +515,17 @@ spmi_bus: spmi@1c40000 {
> #interrupt-cells = <4>;
> };
>
> + tsens0: thermal-sensor@4410000 {
> + compatible = "qcom,sm6115-tsens", "qcom,tsens-v2";
> + reg = <0x04411000 0x1ff>, /* TM */
> + <0x04410000 0x8>; /* SROT */
> + #qcom,sensors = <16>;
> + interrupts = <GIC_SPI 275 IRQ_TYPE_LEVEL_HIGH>,
> + <GIC_SPI 190 IRQ_TYPE_LEVEL_HIGH>;
> + interrupt-names = "uplow", "critical";
> + #thermal-sensor-cells = <1>;
> + };
> +
> rpm_msg_ram: sram@45f0000 {
> compatible = "qcom,rpm-msg-ram";
> reg = <0x045f0000 0x7000>;
